1-22 (No.MB262)
3.2.3 Removing the CD servo board
(See Figs.5 and 6)
• Remove the traverse mechanism assembly.
(1) From the bottom side of the traverse mechanism assem-
bly, remove the solders from the solder sections
c
. (See
Fig.5)
(2) Remove the wire (yellow) from the solder sections
d
. (See
Fig.5)
(3) Remove the wire (white) from the solder sections
e
. (See
Fig.5)
(4) Remove the two screws
C
attaching the CD servo board.
(See Fig.5)
(5) Remove the CD servo board from the claws
f
in the direc-
tion of the arrow and turn the CD servo board over. (See
Fig.5)
(6) Solder the short land sections
g
on the CD pickup. (See
Fig.6)
(7) Release the lock of the connector
CN601
on the CD servo
board in the direction of the arrow and disconnect the card
wire. (See Fig.6)
Caution:
• Solder the short land sections
g
on the CD pickup before dis-
connecting the card wire from the connector
CN601
on the
CD servo board. If the card wire is disconnected without at-
taching solder, the CD pickup may be destroyed by static
electricity. (See Fig.6)
• When attaching the CD servo board, be sure to remove sol-
ders from the short land sections
g
after connecting the card
wire to the connector
CN601
on the CD servo board. (See
Fig.6)
Fig.5
Fig.6
Traverse mechanism assembly
CD servo board
Wire (yellow)
Wire (white)
Solder section
c
Solder
section
d
Solder
section
e
C
C
Claw
f
Claw
f
CD pickup
Short land section
g
Traverse mechanism assembly
CD servo board
CN601
Lock
