– 21 –
Specifications
Design and specifications are
subject to change without notice.
UX-P7 (CA-UXP7 and SP-UXP7)
Amplifier
Output Power
SUBWOOFERS:
110 W (55 W + 55 W) at 6
Ω
(MAX.)
70 W (35 W + 35 W) at 6
Ω
(10 % THD)
MAIN SPEAKERS:
36 W (18 W + 18 W) at 6
Ω
(MAX.)
30 W (15 W + 15 W) at 6
Ω
(10 % THD)
Audio input sensitivity/Impedance (at 1 kHz)
AUX:
400 mV/48 k
Ω
Audio output level
AUX:
260 mV/5.8 k
Ω
Digital output — OPTICAL DIGITAL OUT
Signal wave length:
660 nm
Output level:
–21 dBm to –15 dBm
Speakers/Impedance
6
Ω
– 16
Ω
Tuner
FM tuning range
87.5 MHz – 108.0 MHz
AM tuning range
531 kHz – 1 710 kHz
CD player
Dynamic range
85 dB
Signal-to-noise ratio
90 dB
Wow and flutter
Immeasurable
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
Troubleshooting
Symptom
No sound is heard.
Hard to listen to broadcasts because of
noise.
The disc tray does not open or close.
The disc does not play.
The disc sound is discontinuous.
The cassette holder cannot be opened.
Impossible to record.
Operations are disabled.
Unable to operate the unit from the remote
control.
Cause
• Connections are incorrect or loose.
• Headphones are connected.
• Antennas are disconnected.
• The AM loop antenna is too close to the
unit.
• The FM antenna is not properly extended
and positioned.
The AC power cord is not plugged in.
The disc is placed upside down.
The disc is scratched or dirty.
Power supply from the AC power cord has
been cut off while the tape was running.
Small tabs on the back of the cassette are
removed.
The built-in microprocessor may
malfunction due to external electrical
interference.
• The path between the remote control and
the remote sensor on the unit is blocked.
• The batteries are exhausted.
Action
• Check all connections and make
corrections. (See pages 6 to 8.)
• Disconnect the headphones.
• Reconnect the antennas correctly and
securely.
• Change the position and direction of the
AM loop antenna.
• Extend the FM antenna at the best
position.
Plug the AC power cord.
Place the disc with the label side up.
Clean or replace the disc. (See page 20.)
Turn on the unit.
Cover the holes with adhesive tape.
Unplug the AC power cord and then plug it
back in.
• Remove the obstruction.
• Replace the batteries.
Cassette deck
Frequency response
Normal (type I):
50 Hz – 14 000 Hz
Wow and flutter
0.15 % (WRMS)
General
Power requirement
AC 110 V/AC 127 V/AC 220 V/
AC 230 V – 240 V
, adjustable with
the voltage selector, 50 Hz/60 Hz
Power consumption
90 W (at operation)
6.9 W (on standby)
Dimensions (approx.)
525 mm x 305 mm x 249 mm (W/H/D)
(20
7
/
8
in. x 12
1
/
16
in. x 9
7
/
16
in.)
Mass (approx.)
12.7 kg (28.1 lbs)
Supplied Accessories
See page 6.
Speaker
Speaker units
Subwoofer 13.5 cm (5
3
/
8
in.) cone x 1
Woofer 8.0 cm (3
3
/
16
in.) cone x 1
Tweeter 2.0 cm (
13
/
16
in.) cone x 1
Impedance
Subwoofer:
6
Ω
Main speaker:
6
Ω
Dimensions (approx.)
170 mm x 305 mm x 253 mm (W/H/D)
(6
3
/
4
in. x 12
1
/
16
in. x 10 in.)
Mass (approx.)
3.5 kg (7.8 lbs)
EN16-22_UX-P7[A]f
01.5.25, 9:39 AM
21
