(No.49787B)1-7
3.1.2 Removing the top cover
(See Fig.5 to 9)
(1) Remove the four damper bracket fixing screws
C
to re-
move the damper brackets.
(2) Pull out the dampers, being careful not to damage them.
When reattaching a damper, insert your finger to push out
the center of the damper to mount it on the damper shaft,
as shown in Fig. 6-1.
(3) Turn the damper spring bracket toward the top at a right an-
gle as shown in Fig. 7, then push down the lower side of the
damper spring bracket to lift it off.
(4) Remove the three fixing screws
D
and
E
on the DIN jack
board assembly.
(5) Lift the changer unit upward.
(6) Remove the damper springs from the mechanism chassis
if required. To reassemble, refer to the diagram below.
Fig.5
Fig.6
Fig.6-1
Fig.7
Fig.8
Fig.8-1
Fig.9
C
C
Damper
Damper bracket
Damper
Damper bracket
Damper
Damper bracket
Damper
Apply alcohol to the shaft then immediately
attach the damper. (After attaching, check
that the shaft is correctly inserted.)
Push out with your finger
before attaching
Damper shaft
Damper
Turn to the top position (at a right angle),
then push down to lift off.
Damper spring bracket
Lift the changer unit upward
How to attach the damper springs
Silver
(mechanism side)
Black
(magazine side)
Mechanism
Chassis
Damper spring
Damper spring
Remove the flexible ribbon
wire if required
E
E
D
DIN jack board
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
