Int. Mic Separation
For setting the enhancement level of the stereo
effect of the built-in microphone.
0
On:
Enhances the stereo effect.
0
Off:
Does not enhance the stereo effect.
[Setting Values:
R
On, Off]
Memo :
0
Both [CH1] and [CH2] selection switches are set
to “INT”.
0
When [Int. Mic Separation] is set to “On”, a
icon is displayed on the status screen (audio
input) while the function is operating.
Test Tone
For specifying whether to output the audio test
signals (1 kHz) during color bar output.
[Setting Values: On,
R
Off]
INPUT1/2 Wind Cut
For selecting whether to cut the low frequencies of
the audio input signals (low-cut) when the [INPUT1/
INPUT2] switch is set to “MIC” or “MIC+48V”.
Set this item to reduce wind noise from the
microphone.
0
Both:
Enables low-cut on both the [INPUT1] and
[INPUT2] terminals.
0
INPUT2:
Enables low-cut on the audio of the [INPUT2]
terminal only.
0
INPUT1:
Enables low-cut on the audio of the [INPUT1]
terminal only.
0
Off:
Disables low-cut.
[Setting Values: Both, INPUT2, INPUT1,
R
Off]
Int. Mic Wind Cut
For selecting whether to cut the low frequencies of
the audio input signals (low-cut) from the built-in
microphone. Set this item to “On” to reduce wind
noise from the microphone.
[Setting Values: On,
R
Off]
Equalizer
You can correct the characteristic and enhance the
sound of the connected microphone using this
equalizer setting.
For setting the audio frequency from a 5-band
equalizer.
0
Frequency:
100Hz, 330Hz, 1kHz, 3.3kHz, 10kHz
0
Variable level:
± 6dB (1dB step)
Memo :
0
Audio will be recorded in the characteristic set
in the equalizer.
0
Set all bands to “0 dB” to bypass the equalizer.
0
When the equalizer level is set to the + side, the
audio may be distorted. In this case, reduce the
recording level in Manual mode.
0
If the values of multiple frequencies are
changed, the specified levels and the actual
levels may be different due to interference
between the frequency bands.
0
This function is enabled only when both
[INPUT1/2 Wind Cut] and [Int. Mic Wind Cut] are
set to “Off”.
Monitor
For setting the audio sound of the [
x
] terminal to
stereo or mixed sound when the [MONITOR]
selection switch on the LCD monitor is set to
“BOTH”.
0
Mix:
Outputs mixed sound (mixed sound of CH1 and
CH2) to both L and R.
0
Stereo:
Outputs stereo sound (outputs audio sound of
CH1 to L, and CH2 to R).
[Setting Values:
R
Mix, Stereo]
Memo :
0
If both CH1 and CH2 are built-in microphones,
stereo sound is output from the [
x
] terminal
regardless of the [Monitor] setting.
136
A/V Set Menu
Menu Display and Detailed Settings
Summary of Contents for Connected Cam GY-HC500E
Page 2: ...2 ...
Page 267: ...267 ...
