2
ENGLISH
If your receiver is equipped with Line Output, connect as in
A
. If your receiver is NOT equipped
with Line Output, connect as in
B
.
CONNECTIONS
CAUTIONS
To prevent short circuits while making connections, keep the battery’s negative terminal
disconnected.
•
When using a power cord (purchased separately), be sure to place the 30 A fuse near the
battery as shown.
•
Connect the lead wire (power cord) through which power is supplied directly to the battery’s
+
terminal only after all the other connections have been made.
The proper lead wire connected to each POWER terminal is as follows.
•
+ B
and
GND
: cross section of more than 8 mm
2
•
REM
: cross section of 0.5 mm
2
to 1 mm
2
A
B
Line output of
receiver
Remote output wire of receiver
Gray
Left (
b
)
Left (
a
)
Right (
b
)
Right (
a
)
Connect to battery “
+
“.
Screw (not supplied)
Connect to the metallic body (chassis and so on)
of the car.
Gray / Black
White
White / Black
30 A fuse
(not supplied)
Speaker input connector
(supplied)
Audio cord
(not supplied)
Speaker output of receiver
Insulation tape (supplied)
After connection ,wrap the
insulation tape around the
terminals.
CS-BGS5120_EN.book Page 2 Monday, May 14, 2007 8:37 PM
