3
Turn off the power
Remote control: press the
B
[STAND BY] button
Projector unit: press the
A
[STANDBY/ON] button
0
While the “Are you sure you want to turn off?” message is displayed, press the button again.
0
The lamp turns off, and the “STANDBY/ON” indicator switches from a green light to a red blinking light.
0
After the light goes off, the fan will run for about 100 seconds to cool down the lamp (Cool-down mode).
Do not disconnect the power cable while cooling is in progress.
0
After about 100 seconds, the “STANDBY/ON” indicator switches from a blinking red to a solid red light.
.
LAMP
WARNING
STANDBY/ON
LAMP
WARNING
STANDBY/ON
ND
TANDBY
In standby state
“STANDBY/ON” lights up (red)
In the Cool-down mode
“STANDBY/ON” blinking (red)
0
(
V
) Attach the lens cover.
0
(
X
W
) The motorized lens cover opens.
CAUTION
0
The power cannot be turned off within approximately 60 seconds after it has been turned on.
0
After the light goes off, the fan will run for about 100 seconds to cool down the lamp (Cool-down mode).
Do not disconnect the power cable while cooling is in progress.
0
The power cannot be turned on again while cooling is in progress (100 seconds).
0
Pull out the power plug when the unit is not to be used for a prolonged period of time.
26
Operate
Summary of Contents for D-ILA DLA-RS49
