Masterpage:Right-FullCol
EN
29
Filename [HM-DH5U_Eng.fm]
Basic Playback
Features
A
Checking tape position
The position of “
Z
” in relation to “B” (Beginning) or “E”
(End) shows you where you are on the tape.
NOTES:
•
“SUPERIMPOSE” must be set to “ON”, or the indicator will
not appear (
•
It may take a few seconds for the tape position indicator to be
displayed.
To reset the time counter,
press [C. RESET] on the
Remote. The counter reading becomes “0:00:00”. It is
also reset when a tape is inserted.
B
Playing back tape repeatedly
— Repeat Playback
You can play back a tape repeatedly (50 times).
While playing back a tape, press and hold [PLAY (
I
)] for
more than 5 seconds.
The play indicator [
E
] on the front display panel starts
flashing slowly, and a tape will be played back 50 times.
To stop playback,
press [STOP (
L
)] on the Remote or on
the front panel.
NOTE:
For a cassette recorded in D-VHS mode, Repeat Playback is not
possible if the cassette was recorded in LS3 mode.
•
Turn on the VCR and the TV, and select the AV
mode on the TV.
•
Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
E
E
B
D
C
F
[PLAY(
I
)]
[STOP (
L
)]
[POWER]
[TIMER ( )]
[FF (
N
)]
[REW (
O
)]
[
S
]
[
T
]
[C.RESET]
C
G
D
B
E
G
VCR
TV
CABLE
/DBS
The tape position indicator
appears on the screen in the
following cases:
•
When you change the VCR
operation mode from the
stop mode to fast forward
or rewind mode.
•
When you perform an
Index Search (
B
E
HM-DH5U_Eng.fm Page 29 Friday, June 25, 2004 11:42 AM
