Masterpage:Right-FullCol
EN
49
Filename [HM-DH5U_Eng.fm]
Video Remote
Control Timer
Programming
This VCR can perform analog recording of a program
which is timer-programmed on your Integrated HDTV (or
Digital Set Top Box).
A
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape before inserting
the cassette.
B
Select analog input location on
the VCR
On the front panel:
Press [C] or [–] to select “L-1” etc.
On the Remote:
a–
Press [TV/VCR CH +] or [–] to select “L-1” etc.
or
b–
Press the ‘Number’ key [0(AUX)].
C
Set recording speed
Press [REC SPEED] to set the recording speed.
D
Set timer program on the Inte-
grated HDTV
•
For timer programming method, refer to the
manual of the Integrated HDTV.
E
Engage recording standby mode
Press [POWER] to turn off the VCR.
•
The Integrated HDTV will activate the VCR to
automatically start recording through the Video
Remote Controller at the programmed time.
•
Turn on the VCR and the TV (and/or Digital Set Top
Box).
•
Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
A
B
C
E
B
- a
B
- b
[AUX]
E
C
VCR
TV
CABLE
/DBS
HM-DH5U_Eng.fm Page 49 Friday, June 25, 2004 11:42 AM
