16
Adjusts the video settings according to the installation environment to
minimize any influence on the image quality by objects, such as white
walls or indirect illumination.
SpyderX Elite/Pro sensor is required when using the Environment
Settings feature.
1
Click the “Environment Setting” button.
2
Connect the optical sensor to the PC.
After connection is established, click the “SpyderX” button.
3
Install the Optical Sensor.
Measure the intensity of ambient light (amount of flare).
Make sure that the intensity of the ambient light is the same as that
of the environment where the projector is used.
While measuring the ambient light, make sure that there are no
changes in the surrounding conditions (light). Otherwise, the
measurements may be affected.
4
After installation is complete, click the “>>” button.
5
Install the Optical Sensor.
Measure the intensity of the projected light.
Make sure that the intensity of the ambient light is the same as that of
the environment where the projector is used.
Environment Settings
Click
Click
30 cm
Screen
Ambient Light Sensor
Installation Example
When measuring the intensity of
ambient light, place the optical sensor
parallel to the screen at a position
where light from the projector does not
fall directly on the optical sensor
(approximately 30 cm away from the
edge of the projected image). At the
same time, make sure the ambient light
sensor is facing the projector.
Click
30 cm
Screen
Ambient Light Sensor
Installation Example
Position the optical sensor at
approximately 30 cm from
the edge of the projected
image with it in contact with
the screen, and make sure
the ambient light sensor is
facing the projector.