13
Item
Setting value
Content
Initial Param
Menu
Control Mode
Start Mode
Sync Mode
TS Rate
Video Mode
Audio Format
Audio Input
Audio ExDelay
Audio Enable
Local
Remote
Auto
Manual
HD-IN
REF
10000kbps
to
21000kbps
to
50000kbps
1080i
720p
MPEG
DD-PT
(Dolby™ Digital Pass
Through)
AES/EBU
EMB
1ms
to
10ms
to
500ms
ON
OFF
Set the operation mode of this unit.
Local
: Set to this mode when operating this unit
using the buttons on the front panel.
Remote : Set to this mode when using RS-232C
terminal
$
on the rear panel to perform
remote control of this unit.
Set the starting mode of encoding.
Auto
: Start the encoding automatically.
Manual : Start the encoding using the menu.
☞
Page 18 “Starting the Encoding”
Set the synchronized signal that is the reference for encoding.
HD-IN : Synchronize with the input video signal.
REF
: Synchronize with the D1 signal input into
REF IN terminal
@
on the rear panel.
Set the TS bit rate.
The setting value can be changed in 10 kbps step.
Set the Video Mode.
Encode with 1080i: 1080i format.
Encode with 720p: 720p format.
Setting the Audio Format.
MPEG : Encoding with MPEG Layer
2
.
DD-PT(Dolby™ Digital Pass Through) :
Dolby™ Digital bitstream will be output in TS
Format.
Select the input audio signal.
AES/EBU : Encode the audio signal input into AES/EBU
terminal
#
on the rear panel.
EMB
: Encode the Embedded audio signal
input into HD-SDI IN terminal
9
on the
rear panel.
This setting is meant for compensating the delays
introduced when encoders are connected to
external equipment.
(Denary, Millisecond unit)
Setting value is 1 ms step variable.
Set whether to output audio signal or not.
ON : Output audio information.
OFF : Does not output audio information.
Men
u setting
When input video sig-
nal is used in synchro-
nized mode, video sig-
nal may not output for
about 20 seconds due
to switching of signal or
reconnection of signal
cable.
The setting value of the
Video Rate item in the Op-
erate Param Menu may
change if TS Rate setting
value is changed.
The setting value of the Asp
item in the Operate Param
Menu may change if Video
Mode setting value is
changed.
Configuration Menu
Memo
Memo
Memo
Memo
Memo
Memo
: Default setting
Memo
Memo
This setting is only valid
when Audio Format is set
as DD-PT (Dolby™ Digital
Pass Through).
