19
Basic operation
Operation Flow Chart
Display Flow Chart
Set the Start Mode item
in the menu to “Manual” ac-
cording to the procedure on
☞
Page 18 “Start the
encoding automati-
cally”.
Operation Flow Chart
Display Flow Chart
The encoding will stop if menu
item has been changed dur-
ing manual encoding and
“>Save&Reboot” has been
excecuted.
Start the encoding manually
once again.
Main Menu
+ C o n f i g u r a t i o n M e n u
C o n f i g u r a t i o n M e n u
+ O p e r a t e P a r a m M e n u
O p e r a t e P a r a m M e n u
V i d e o R a t e : 2 0 0 0 0 k b p s
O p e r a t e P a r a m M e n u
>Start?
Main Menu
+ C o n f i g u r a t i o n M e n u
C o n f i g u r a t i o n M e n u
+ O p e r a t e P a r a m M e n u
O p e r a t e P a r a m M e n u
V i d e o R a t e : 2 0 0 0 0 k b p s
O p e r a t e P a r a m M e n u
>Stop?
Start the encoding manually
Stop the encoding manually
Press the ENTER button
Main Menu screen will be displayed.
Press the
8
/
9
buttons
Select the Configuration Menu and press the ENTER
button.
Press the
8
/
9
buttons
Select the Operate Param Menu and press the EN-
TER button.
Press the
8
/
9
buttons
Select the Stop item and press the ENTER button.
Press the ENTER button
Stop the encoding.
Press the ENTER button
Main Menu screen will be displayed.
Press the
8
/
9
buttons
Select the Configuration Menu and press the ENTER
button.
Press the
8
/
9
buttons
Select the Operate Param Menu and press the EN-
TER button.
Press the
8
/
9
buttons
Select the Start item and press the ENTER button.
Press the ENTER button
This starts the encoding.
Memo
Memo
