47
Operations
2
-
1Å@ÉpÉ\ÉRÉìÇÃIPÉAÉhÉå
To play the stream from ISMA Server mode, ISMA-complaint player is required.
There are 2 types of streaming: unicast that is available only for one client, and multicast that
is available for multiple clients. Operation of player differs depending on the streaming type.
Operating the ISMA Server System
For unicast
1.
Set the IP address of the PC for connection
with DM-NC40.
See “Setting the IP Address”, pages 20 and 22
2.
Launch the ISMA-compliant player.
3.
Select “Open URL”
Enter:
“rtsp://*.*.*.*/Iive.mp4”
(*.*.*.* is the IP address of DM-NC40)
4.
To stop, close the player by clicking
on the
top right of the window.
POWER
IN 2
IN 1
HOLD
DECODE
ENCODE
CF
PLAY
STOP
HOLD
SELECT
P P
in
Network
Network
Server side
Player side
Number display
Memo
Make sure the same IP addresses have not been
set within the same network.
For multicast
1.
Set the IP address of the PC for connection
with DM-NC40.
See “Setting the IP Address”, pages 20 and 22.
2.
Launch the Web browser
In Network Setup of the unit (
page 30), set the
Multicast stream start button to “ON”.
The multicast stream is transmitted from the DM-
NC40.
3.
Receive multicast streams with an ISMA-
compliant player
For receiving multicast stream, contact the nearest
JVC-authorized service agent.
Memo
•
UP to 5 players can be connected simulta-
neously for unicast. (Number of players will be
counted as 2 even if connections from 2 play-
ers are from the same PC.)
Perform the following steps on PC.
Memo
When transmitting multicast streams from multiple
DM-NC40 units, make sure the same multicast IP
addresses or port numbers are not used.
Number display during transmission
Number of unicast clients(0-5)
0: Multicast transmission not in progress
1: Multicast transmission in progress
Memo
Summary of Contents for DM-NC40
Page 59: ...59 ...
