1-18 (No.YD085)
3. [3] Middle catcher assembly/ [4] Reel cover assembly
Fig.4-5-3
< Note 3a >:
Once the reel cover assembly has been removed, the parts
located below it tend to slip out easily: Be careful.
< Note 3b >:
When attaching these screws, screwing order (a),(b),( c)
4. [5] Pinch roller arm assembly/[6] Sub brake assembly/[7] Band arm plate sub assembly/ [8] Tension arm sub assembly
Fig.4-5-4
Fig.4-5-4a
Fig.4-5-4b
< Note 4a >:
When attaching this part, fit it in the boss (L7) on the charge
arm assembly.
< Note 4b >:
When attaching or removing this part, take care of the han-
dling of the band section.
< Note 4c >:
After fitting the spring on the shaft, engage it with hook [a]
first then with hook [b] .
After attaching it, set it to the positioning shown in "Step 3"
and confirm that band arm plate sub assembly [7] can be ro-
tated in the direction of the arrow as shown below.
13
(S2)
(L6)
(L6)
<Note3a>
(a)
(b)
(c)
Apply grease
12
(S2)
<Note3b>
10
(S2)
<Note3b>
11
(S2)
<Note3b>
[4]
[3]
(W1)
(W2)
14
(S3)
(P2)
(L9)
(L7)
(L8)
(W1)
(P1)
(P3)
<Note 4c>:
How to install the spring
<Note4a>
<Note4b>
NOTE4c
Step 1
Step 2
Step 3
Hook [a]
Hook [b]
[7]
[8]
[5]
[6]
sub brake (Take up)
OK
NG
spring hooked
reverse-side
