Masterpage:Right+
EN
75
Filename [DR-MV1SEK_09Editing.fm]
Page 75
April 15, 2004 3:18 pm
EDITING
NOTES:
●
If you have a satellite receiver or a decoder connected to the L-2 IN/
DECODER connector, be sure to set “L-2 SELECT” back to
appropriate mode after editing.
●
If you are not connecting a satellite receiver or a decoder to the L-2
IN/DECODER connector, leave “L-2 SELECT” set to “VIDEO”.
●
When “L-2 SELECT” is set to “SAT VIDEO” and “SAT S-VIDEO”,
“SAT” appears on the TV screen or front display panel instead of
“L-2”.
●
If “L-1 OUTPUT” is set to “SCART S-VIDEO”, it is not possible to set
“L-2 SELECT” to “DECODER” or “SAT VIDEO”.
●
If “L-1 OUTPUT” is set to “SCART RGB”, it is not possible to set “L-2
SELECT” to “DECODER” or “SAT S-VIDEO”.
●
If “L-1 OUTPUT” is set to “COMPONENT” and “L-2 SELECT” to “SAT
VIDEO”, “SAT S-VIDEO” or “DECODER”, be sure to connect the L-1
IN/OUT connector with a TV.
F-1 Input Setting
Set “F-1 INPUT” to the appropriate mode depending on the
connector (VIDEO or S-VIDEO) being used on the front panel.
1
Perform steps
1
and
2
of “L-1 Output And L-1 Input Setting”
(
墌
pg. 74).
2
Press
rt
to select “F-1 INPUT”, then press
ENTER
.
3
Press
rt
to select the
appropriate setting, then press
ENTER
.
4
Press
SET UP
to complete the
setting.
* The
boldface
settings below
indicate the settings at your
purchase.
8
F-1 INPUT
—
VIDEO
/ S-VIDEO
VIDEO
: When connecting an appliance to the VIDEO input
connector, set to “VIDEO”.
S-VIDEO
: When connecting an appliance to the S-VIDEO input
connector, set to “S-VIDEO”.
You can dub selected audio from a DVD or Audio CD disc to a
digital audio device.
However, it is not possible to dub copy-protected discs.
Example: Dubbing to an MD
1
Connect the unit and a digital audio device using either an
optional optical cable or an optional coaxial cable.
2
Place a disc on the unit and load an MD on the connected digital
audio device.
3
Select the audio to be dubbed.
4
Start playback slightly before the actual point from where you
wish to start dubbing.
5
Press
9
to pause playback.
6
Select the input mode on the connected digital audio device.
7
Press
4
to start playback on the unit.
8
Start recording on the digital audio device.
9
Stop recording on the digital audio device. Then press
8
to stop
playback on the unit.
NOTE:
There may be a discrepancy of several seconds between where you
intend editing to start, and where it actually starts.
Digital Audio Dubbing
●
Turn on the TV and select the AV mode.
●
Slide the
TV/CABLE/SAT/DVD
switch to
DVD
.
2
Rear of unit
Note for connection:
Remove the protection cap from the cable.
Digital audio device
(MD deck, etc.)
Optical cable
(not provided)
DIGITAL AUDIO OUT
(OPTICAL)
Player
Recorder
Coaxial cable
(not provided)
DIGITAL AUDIO OUT
(COAXIAL)
DR-MV1SEK_00.book Page 75 Thursday, April 15, 2004 3:30 PM
