Masterpage:Right+
EN
41
Filename [MX1S_06DVD Operation.fm]
BASIC OPERATIONS ON DVD DECK
Page 41Saturday, 30 October 2004 16:18
1
Load a recordable disc.
●
For details, refer to “Placing A Disc” (
2
Press
VHS/HDD/DVD SELECT
on the unit repeatedly or
DVD
on the remote so that the DVD lamp lights up on the unit.
3
Press
CH +/–
or the
number keys
to select the channel you
wish to record.
4
Press
REC MODE
repeatedly to select the recording mode,
then press
ENTER
.
●
Each time you press
REC MODE
, the recording mode changes as follows:
XP
]
SP
]
LP
]
EP
]
FR60–FR360*
]
FR420, FR480
]
(Back
to the beginning)
* The value is selectable from 1 to 6 hours in 5-minutes interval by
pressing
w e
repeatedly after selecting “FR60–FR360”. To change the
value in 30-minutes interval, press and hold
w e
.
●
For details on the recording mode, see the right column.
5
Press
7
on the unit to start recording. Or while holding
7
, press
4
on the remote control.
●
The DVD recording lamp lights up on the unit.
6
Press
7
and
9
on the remote control simultaneously to pause
recording.
●
To resume recording, press
7
and
4
simultaneously.
7
Press
8
twice to stop recording.
●
It takes about 10 seconds to end the writing session when you stop
recording.
NOTES:
●
It is recommended to format a DVD-RAM disc before use if you use
the disc on this unit for the first time.
●
When using a brand-new DVD-RW disc, format the disc either in VR
mode or in Video mode. (
●
Recordings made on DVD-R/RW disc must be finalized to play back
on other DVD players. Perform “Finalize A Disc (DVD Deck Only)”
(
●
You can record up to 99 programs and 999 play lists on each disc.
●
Some programs can only be recorded one time.
●
When recording is started, an index of the first part of recording is
automatically recorded. (
pg. 63) To record satellite programs,
refer to page 59. To delete the index, refer to page 65.
●
Recording sometimes may stop or cannot be performed even if there
is enough available capacity remaining on the disc.
●
It is not possible to record on both DVD and HDD simultaneously.
Recording Mode
MPEG2 format is used as recording format. As a guide for picture
quality, the “bps” unit is used to represent how much data can be
recorded per second. The larger this value is, the better the picture
quality becomes but more capacity is required for the recording.
Select XP or SP for programs where quick movement occurs, such
as sports programs, and LP or EP for talk shows, etc. with
relatively less movement.
The recording modes for a 4.7 GB disc are set as follows:
●
For details on FR mode, refer to “Free Rate Function” (
Basic Recording
●
Turn on the unit.
●
Turn on the TV and select the video channel (or AV mode).
●
Slide the
TV/CABLE/DBS/DVD
switch to
DVD
.
ATTENTION:
It is not possible to record programs on a DVD-R disc which has
already been finalized.
7
REC
MODE
CH +/
8
4 9
VHS/HDD/DVD
SELECT
4
7
0-9
REC MODE
DVD
CH+/-
9
8
CABLE/DBS
DVD
TV
ENTER
Recording
mode
Recording amount
(approx.)
Maximum recording
time (approx.)
XP
10 Mbps
1 hour
SP
5 Mbps
2 hours
LP
2.5 Mbps
4 hours
EP
1.6 Mbps
6 hours
FR60–FR360
(
The amount varies
depending on the
selected time.
1 – 6 hours
FR420
7 hours
FR480
8 hours
MX1S_00.book Page 41 Saturday, October 30, 2004 4:18 PM
