1-44 (No.MB531)
3.3.7 Removing the DVD pickup
(See Figs.12 to 14)
• Remove the tray assemblies, DVD servo board and DVD
traverse mechanism assembly.
(1) From the top side of the DVD traverse mechanism assem-
bly, release the lock of the connector on the DVD pickup
and disconnect the card wire in the direction of the arrow.
(See Fig.12.)
(2) Turn the screw shaft gear in the direction of the arrow 1 to
move the DVD pickup in the direction of the arrow 2. (See
Fig.12.)
(3) Remove the screw
G
attaching the feed bracket and re-
move the feed bracket from the sections
k
. (See Fig.12.)
(4) Release the claw
m
of the thrust spring in the direction of
the arrow and remove the thrust spring. (See Fig.12.)
(5) Remove the guide shaft from the sections (
n
,
p
) on the
C.TM chassis. (See Fig.13.)
(6) Remove the section
q
of the DVD pickup. (See Fig.13.)
(7) Remove the two screws
H
attaching the rack arm spring
and rack arm. (See Fig.14.)
(8) Pull the guide shaft from the DVD pickup in the direction of
the arrow. (See Fig.14.)
3.3.8 Attaching the DVD pickup
(See Figs.12 to 14)
(1) Attach the guide shaft to the DVD pickup and attach the
rack arm spring and rack arm with the screws
H
. (See
Fig.14.)
(2) Attach the section
q
of the DVD pickup to the C.TM chassis
first and attach the guide shaft to the sections (
n
,
p
). (See
Fig.13.)
Reference:
When attaching the guide shaft to the section
p
, attach it
under the rod spring. (See Fig.13.)
(3) Attach the thrust spring and feed bracket with the screw
G
.
(See Fig.12.)
(4) Turn the screw shaft gear in the direction of the arrow 1 to
move the DVD pickup in the direction of the arrow 2. (See
Fig.15.)
(5) Connect the card wire to the connector on the DVD pickup.
(See Fig.15.)
Fig.12
Fig.13
2
1
Thrust spring
Thrust spring
DVD pickup
Connector
Screw shaft gear
G
DVD traverse mechanism assembly
k
m
Feed bracket
DVD pickup
Guide shaft
C.TM chassis
n
p
Rod spring
q
