JVC Emerald EM32FL, User Manual

3

ENGLISH

Important Safety Instructions

1)    Read these instructions.
2)    Keep these instructions.
3)    Heed all warnings.
4)    Follow all instructions.
5)    Do not use this apparatus near water.
6)    Clean only with dry cloth.
7)    Do not block any ventilation openings. Install in accordance with manufacturer’s instructions.
8)    Do not install near any heat sources such as radiators, heat registers, stoves, or other 

apparatus (including amplifiers) that produce heat.

9)    Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug  

has two blades with one wider than the other. A grounding-type plug has two blades and a  

third grounding prong. The wide blade or the third prong are provided for your safety. If the  

provided plug does not fit into your outlet, consult an electrician for replacement of the  

obsolete outlet.

10)  Protect the power cord from being walked on or pinched, particularly at plugs, convenience  

receptacles, and the point where they exit from the apparatus.

11)  Only use attachments/accessories specified by the manufacturer.

12)  Use only with the cart, stand, tripod, bracket, or table specified by the 

manufacturer, or sold with the apparatus. When a cart is used, use caution 

when moving the cart/apparatus combination to avoid injury from tip-over.

13)  Unplug this apparatus during lightning storms or when unused for long periods of time.
14)  Refer all servicing to qualified service personnel. Servicing is required when the apparatus 

has been damaged in any way, such as power-supply cord or plug is damaged, liquid has 

been spilled or objects have fallen into the apparatus, the apparatus has been exposed to 

rain or moisture, does not operate normally, or has been dropped.

15)  Apparatus should not be exposed to dripping or splashing, and objects filled with liquids, such 

as vases, should not be placed on the apparatus.

16)  An outside antenna system should not be located in the vicinity of overhead power lines or  

other electric light or power circuits, or where it can fall into such power lines or circuits. When 

installing an outside antenna system, extreme care should be taken to keep from touching 

such power lines or circuits, as contact with them might be fatal.

17)  Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric 

shock.

18)  Do not push objects through any openings in this unit, as they may touch dangerous voltage  

points or short out parts that could result in fire or electric shock. Never spill or spray any type 

of liquid into the unit.

19)  If an outside antenna or cable system is connected to the unit, be sure the antenna or cable  

system is grounded to provide some protection against voltage surges and built-up static 

charges, Section 810 of the National Electrical Code, ANSI/NFPA 70, provides information  

with respect to proper grounding of the mast and supporting structure, grounding of the 

lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna 

discharge unit, connection to grounding electrodes, and requirements for the grounding 

electrode.

20)  When replacement parts are required, be sure the service technician uses replacement parts 

specified by the manufacturer or those that have the same characteristics as the original part. 

Unauthorized substitutions may result in fire, electric shock or other hazards.

21)  Upon completion of any service or repairs to this unit, ask the service technician to perform 

safety checks to determine that the unit is in proper operating condition.

Important Safety Instructions