EN
29
MasterPage: Start_Right
Connections/Editing
EN
G
L
ISH
It is also possible to copy recorded scenes from
the camcorder onto another video unit
equipped with a DV connector. Since a digital
signal is sent, there is little, if any, image or
sound deterioration.
To use this camcorder as a player
Make sure all units are turned off.
Connect this camcorder to a video unit
equipped with a DV input connector
using a DV cable as shown in the
illustration.
Start playback on the camcorder
(
墌
16).
At the point you want to start dubbing,
start recording on the video unit. (Refer
to the video unit’s instruction manual.)
To stop dubbing, stop recording on the
video unit, then stop playback on this
camcorder.
Notes:
●
It is recommended to use the AC Adapter as
the power supply instead of the battery pack
(
墌
11).
●
If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not
dubbed.
●
Even though the DV cable is connected
correctly, sometimes the image may not appear
in step
. If this occurs, turn off the power and
make connections again.
●
If SNAPSHOT is pressed during playback, only
the original playback image recorded on the
tape is output from the DV IN/OUT connector.
●
When using a DV cable, be sure to use the
optional JVC VC-VDV204U or VC-VDV206U DV
cable.
To use this camcorder as a recorder
Make sure all units are turned off.
Connect this camcorder to a video unit
equipped with a DV output connector using
a DV cable as shown in the illustration.
Set the camcorder's Power Switch to
“PLAY”
.
Set
“REC MODE”
to
“SP”
or
“LP”
. (
墌
20)
Press the Recording Start/Stop Button to
engage the Record-Pause mode.
●
The “
” indication appears on the
screen.
Start playback on the player.
At the point you want to start dubbing,
press the Recording Start/Stop Button
again to stop dubbing. The
T
indication
rotates.
Press the Recording Start/Stop Button
again to stop dubbing. The
T
indication
stops rotating.
Press
8
to return to the normal playback
mode.
Note:
Digital Dubbing is performed in the sound mode
recorded on the original tape, regardless of the
current “SOUND MODE” setting
(
墌
20).
.
Dubbing To Or From A Video
Unit Equipped With A DV
Connector (Digital Dubbing)
Core Filter
To DV IN/OUT
DV Cable (optional)
To DV IN/OUT
Video unit equipped with DV connector
1
1
1
1
2
2
2
2
3
3
3
3
4
4
4
4
5
5
5
5
COPY PROTECTED
Appears if dubbing of copyguarded signals is
attempted while this camcorder is being
used as a recorder.
4
4
4
4
1
1
1
1
2
2
2
2
3
3
3
3
4
4
4
4
5
5
5
5
DV IN
6
6
6
6
7
7
7
7
8
8
8
8
9
9
9
9
Connections/Editing
GR-D850AA_EN.book Page 29 Thursday, October 18, 2007 5:26 PM
