EN
61
PAUSE
START/STOP
INSERT
PLAY
REW
PL
AY
OFF
TC 1 2 : 3 4
6w
STOP
Insert Editing
You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in and outpoints. The
original audio remains unchanged.
NOTES:
●
Before performing the following steps, make sure that
“TIME CODE” is set to “ON” in the Menu Screen
(
pg. 34).
●
Insert Editing is not possible on a tape recorded in the LP
mode or on a blank portion of a tape.
●
To perform Insert Editing while watching in the
television, make connections (
pg. 42).
1
Play back the tape, locate the Edit-Out point and
press
PAUSE
(
6
). Confirm the time code at this point
(
pg. 35).
2
Press
REW
(
2
) until the Edit-In point is located, then
press
PAUSE
(
6
).
3
Press and hold
INSERT
(
w
) on the remote control,
then press
PAUSE
(
6
). “
6w
” and the Time Code
(min.:sec.) appear and the camcorder enters Insert-
Pause mode.
4
Press
START/STOP
to begin editing.
•Confirm the insert at the time code you checked in
step
1
.
•To pause editing, press
START/STOP
. Press it again
to resume editing.
5
To end Insert Editing, press
START/STOP
, then
STOP
(
5
).
NOTES:
●
Program AE with special effects (
pg. 30) can be used
to spice up the scenes being edited during Insert Editing.
●
During Insert Editing, the date and time information
changes.
●
If you perform Insert Editing onto a blank space on the
tape, the audio and video may be disrupted. Make sure
you only edit recorded areas.
●
During Insert Editing, when the tape moves to scenes
recorded in the LP mode or a blank portion, Insert Edting
stops (
pg. 73).
Power Switch
Lock Button
Display
Remote sensor
