(No.YF034)1-19
5.2
TAKE OUT CASSETTE TAPE
The following procedure is a method for taking out the cassette
tape in case the cassette tape cannot be ejected due to an elec-
trical failure. The following procedure is a simplified method;
therefore, for more reliable operation, it is recommended that you
should remove exterior parts so that you can take out the tape
without excessive force.
(1) Remove the Power Unit (battery or DC cord) from the set.
(2) Open the CASSETTE COVER till it is completely opened
and fixed.
(3) Attach a PVC tape as shown in the figure.
NOTE:
Be careful of cassette tape damage caused because the
Cassette Housing Assembly is moved upward at the un-
loading end (Eject mode).
(4) To set the Slide Deck Assembly to the unloading end, ap-
ply DC 3V to the electrode (terminal) on the top surface of
the LOADING MOTOR that is seen through a space of VF
side.
NOTE:
Be careful not to attach grease or a similar substance to
the surface of the cassette tape on the tape transport
system.
(5) Wind the cassette tape by directly turning the Reel Disk As-
sembly (SUP) from the backside of the SLIDE DECK AS-
SEMBLY by using a sharp tool (Chip IC replacement tool).
(6) Confirm that the cassette tape is completely wound, and
then peel off the PVC tape from the CASSETTE HOUSING
ASSEMBLY and take out the cassette tape.
NOTE:
To confirm that the cassette tape is completely wound,
confirm that one REEL DISK ASSEMBLY (TU) rotates
as you rotate the other REEL DISK ASSEMBLY (SUP).
(7) Make sure that grease or a similar substance is not at-
tached to the surface of the tape taken out in the procedure
(6). Similarly, also make sure that grease or a similar sub-
stance is not attached on the MECHANISM ASSEMBLY,
especially the tape transport system.
Fig.5-2-1
(DC3V)
TAPE
LOADING MOTOR
ASSEMBLY
REEL DISK
ASSEMBLY (SUP)
SLIDE DECK
ASSEMBLY
CASSETTE HOUSING
ASSEMBLY
CASSETTE COVER
