22
EN
INITIALIZATION
INITIALIZING JLIP
The first time you start the Video Capture software, JLIP initialization is required. This sets which
of the computer’s COM ports (connector into which the RS-232C cable is plugged) is connected
to the JLIP Video Capture Docking Station. The initialization window automatically appears the
first time you start the software after installation. Do not forget to carry out this JLIP initialization
procedure. The JLIP must be initialized again whenever you connect a new image source or
other unit to the JLIP Video Capture Docking Station.
1
.
Start the JLIP Video Capture software.
2
.
The “JLIP Initialization” screen automatically appears.
3
.
Select “COM Port”.
•COM1 through COM4 ports are available. Check to see which COM port is connected to
the JLIP Video Capture Docking Station and select it.
4
.
Select “Transfer Rate”.
•Normally select 38400.
•38400 may not be available on some computers. When transmission errors take place
during use, switch to 19200 or 9600. Image data transmission will be slower at these
speeds.
5.
Click “OK”. Call up the “JLIP Initialization” window and check the connected units.
JLIP Initialization
COM Port
COM 1
38400
Transfer Rate
OK
Cancel
NOTE : If you want to change a unit or COM port or Transfer Rate, select “Initialize” from
“Set-up” in the menu bar to call up the “JLIP Initialization” window. Repeat this
setting procedure.
If a connection is incorrect, a connected unit is not turned on, or the connection ID numbers
overlap, the message “Connection error” appears. Click “OK” to return to the Main desktop.
NOTE:
If a connection is incorrect, an error message may be displayed and the connected device
name will not appear on-screen.
•The COM port used for the JLIP connector is not selected, or the COM port is selected but
the connection is wrong. Check the connected COM port and select it on the “JLIP
Initialization” screen.
•The BIOS settings on your PC are not correct. Change the BIOS settings.
Refer to the PC’s instruction manual or consult the computer manufacturer for details.
Summary of Contents for GV-DS2
Page 44: ...44EN MEMO ...
Page 74: ......