11
Operating external components with the remote control
NOTE
• Manufacturers’ codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.
7
To set the manufacturer’s code
You can operate a JVC TV without setting the manufacturer’s code.
1
Slide the remote control mode selector
to TV.
2
Press and hold
TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
4
Press number buttons (1-9, 0) to enter
the manufacturer’s code (2 digits).
Examples:
For a Hitachi TV:
Press
1
, then
0
.
For a Toshiba TV:
Press
0
, then
8
.
5
Release
TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7
Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to
TV
.
The following buttons are available:
TV
:Turns TV on and off.
TV VOL +/–
:Adjusts the volume.
TV/VIDEO
:Selects the input mode (either TV or VIDEO).
C/–
:Changes the channels.
1-10
,
0
,
+10 (100+)
:Selects the channel.
TV RETURN
:Alternates between the previously selected channel
and the current channel.
The buttons described below are used on pages 11 and
12.
Operating the TV
Remote control
mode selector
Number
buttons
(play button)
Manufacturer
Code
Manufacturer
Code
JVC
01
Samsung
12
Hitachi
10
Sanyo
13
Magnavox
02
Sharp
06
Mitsubishi
03
Sony
07
Panasonic
04, 11
Toshiba
08
RCA
05
Zenith
09
TH-S1[USUNUB]-f.book Page 11 Monday, August 2, 2004 1:55 PM