(No.YA092B)1-23
SECTION 4
ADJUSTMENTS
4.1 ADJUSTMENT PREPARATION
(1) You can make the necessary adjustments for this unit
with either the remote control unit or with the
adjustment equipment and parts as given below.
(2) Adjustment with the remote control unit is made on the
basis of the initial setting values, however, the new
setting values which set the screen to its optimum
condition may differ from the initial settings.
(3) Make sure that AC power is turned on correctly.
(4) Turn on the power for the set and test equipment before
use, and start the adjustment procedures after waiting at
least 30 minutes.
(5) Unless otherwise specified, prepare the most suitable
reception or input signal for adjustment.
(6) Never touch any adjustment parts, which are not specified
in the list for this variable resistors, transformers, trimmer
capacitors, etc.
4.2 PRESETTING BEFORE ADJUSTMENT
Unless otherwise specified in the adjustment instructions,
preset the following functions with the remote control unit.
4.3 MEASURING INSTRUMENT AND FIXTURES
1) DC voltmeter (or Digital voltmeter)
2) Oscilloscope
3) Signal generator (Pattern generator)
[ NTSC / 525i / 750p / 1125i / DIGITAL]
4) TV audio multiplex signal generator
5) Remote control unit
4.4 ADJUSTMENT ITEMS
OPTICAL BLOCK / DRIVE CIRCUIT
• LENS FOCUS adjustment
• DRIVE CONVERGENCE adjustment
• DRIVE CENTER POSITION adjustment
VIDEO CIRCUIT
• 525i A-D OFFSET adjustment
• 1125i BRIGHTNESS adjustment
• 1125i A-D OFFSET adjustment
• SUB SCREEN A-D OFFSET adjustment
• WHITE BALANCE (HIGHT LIGHT)
MTS CIRCUIT
• MTS INPUT LEVEL adjustment
• MTS SEPARATION adjustment
Setting item
Settings position
VIDEO STATUS
STANDARD
PICTURE
(TINT / COLOR / BRIGHT/PICTURE /
DETAIL)
All 00
COLOR TEMPERATURE
LOW
DIG. NOISE CLEAR
OFF
COLOR MANAGEMENT
ON
DYNAMIC GAMMA
ON
SOUND
(BASS / TREBLE / BALANCE)
All 00
MTS
STEREO
BBE
OFF
A.H.S
OFF
SMART SOUND
OFF
[HD-52Z585 / HD-61Z585]
ASPECT
FULL
