8
Installation
200mm
150mm
When installing the TV, install it according to the instructions below:
Install the TV on a level and stable surface.
Never expose to rain or moisture.
To prevent fire or electric shock, never allow liquids to enter the unit.
Make enough room for inserting and removing the power plug!
Place the TV as close to the outlet as possible!
The main power supply for this TV is controlled by inserting or removing the power plug.
To avoid overheating, ensure that the unit has ample room.
Connect the power cord only to a 220-240 V, 50 Hz AC outlet
Care when setting
200mm
150mm
Warning
On the front and rear of the TV, pedestals are attached to prevent
the TV from falling over. Do not remove the pedestals for normal use;
otherwise, the TV may fall over and it could cause serious injuries.
Remove the pedestal(s) only in the following cases;
When attaching the TV to the wall
When the instructions supplied for JVC optional goods require you to remove the pedestal(s)
Front pedestal
Rear pedestal
When installing the TV right on the wall
Remove the rear pedestal and install the TV as in the procedure
below.
CAUTION:
Remove the rear pedestal on a level and stable surface.
Use the optional JVC TV stand
Refer to the instructions supplied for the JVC TV stand for installation.
When installing the TV on a TV stand
1
Remove the cover.
2
Remove the screws with a
Phillips type screwdriver.
3
Slide out the rear pedestal
gently.
4
Attach the TV to the wall.
Be sure to install the TV by two persons.
LCT2235-002A-Af.indb 8
LCT2235-002A-Af.indb 8
6/29/2007 4:59:58 PM
6/29/2007 4:59:58 PM