26
DTV
DTV Menu
Timer
Edit PR
Configuration
Setup
Installation
Setup
14:00
05/05/2006
Digital Audio Output
PCM
Banner Duration
2 sec
Receiver Upgrade
Auto
Common Interface
No CI Module
Antenna Power
Off
PCM
Auto
No CI Module
Off
New software found.
Would you like to upgrade now?
In standby
No
Yes
Manual
Software Version
OK
Search for new
3.07.00
Downloading new software
Cancel
To the previous
screen
Exit
1
2
3
4
5
6
select
Display the menu bar
Select “DTV”
Select “Setup”
Select an item
Switch to digital channels
Finish
1
select
2
next
1
select
2
next
DTV setup
Available for setting power supply for the aerial, and upgrading the tuner software,
etc.
Set
Conditional
Access
Module
Common Interface
Power
supply for
the indoor
aerial
Antenna Power
Output the
Dolby Digital
signal
Digital Audio Output
Upgrade
tuner
Receiver Upgrade
Read “Power supply for the indoor aerial” (P. 33) before setting.
1
Press “OK” button to display the
Conditional Access Module menu
2
Follow the instructions on the
screen to set up pay-TV
The content of the menu is different depending on the broadcasting company.
For details, consult your broadcasting company
To watch pay-TV digital channels, use the Conditional Access Module menu.
This function can only be used when pay-TV can be received in your region.
When the Conditional Access Module etc. is
inserted after subscribing to the broadcasting
company, this function is available. “Watch pay-
TV digital channels” (P. 7)
You can upgrade the tuner software as newer versions become available. Normally set to “Auto”.
Banner Duration: Select the display time for channel information (2 sec / 5 sec / 8 sec).
When JVC or the broadcasting station informs you of the new software, download it as follows.
3
Select “Yes”
1
Select “Manual”
If the TV has upgrade to the latest tuner software, the message “Search completed. No new software found
”
will appear.
Select “In standby” instead of “Yes” if you want to upgrade the software automatically when the TV is turned off.
1
select
2
next
1
select
2
next
“Software upgraded
successfully! TV will
now reset!”.
2
Select “Search for new”
If upgrading is not necessary,
select “OK” to finish.
Read ‘“Dolby Digital” output from the “DIGITAL AUDIO OUT” terminal’ (P. 33) before setting.
No CI Module
: Function is not
available
PCM
: The Linear PCM
signal is output
Dolby Digital
: The Dolby Digital signal is output
Only when the Dolby Digital signal is received
Auto
: Automatically download and
install software upgrades
This occurs at midnight when
the TV’s power is off.
Manual
: Manually download and install software
upgrades
When you change the setting, enter
PIN code.
Enter PIN code if needed.
1
select
2
start
Off
: Power not
supplied
On
: Power supplied
LCT2235-002A-Af.indb 26
LCT2235-002A-Af.indb 26
6/29/2007 5:00:17 PM
6/29/2007 5:00:17 PM
