![background image](http://html.mh-extra.com/html/jvc/hm-db1u/hm-db1u_instructions-manual_179088048.webp)
48
EN
The Remote is capable of controlling four JVC video
recorders independently. Each of VCRs can respond to
one of four codes (A, B, C or D).
This Remote control is preset to send A code signals
because your VCR is initially set to respond to A code
signals. You can easily change your Remote and the VCR
to send and respond to B, C or D code signals.
When using four JVC VCRs, set the four VCRs and their
Remotes to different codes, so that the Remotes can
operate these VCRs separately.
1
Set remote operation mode
Set the [VCR/TV/CABLE/DBS] selector to [VCR].
2
Set remote control code for Remote
1
Press and hold [A/B/C/D].
2
Press the ‘Number’ key [1] for A code control
signals, [2] for B code control signals, [3] for C
code control signals and [4] for D code
control signals.
3
Press [STOP (
7
)], and release [A/B/C/D].
3
Turn off VCR
Press [POWER] on the VCR.
4
Check remote control code for VCR
Press [PLAY (
3
)] on the VCR for more than 5
seconds.
●
The code currently set appears on the front
display panel.
5
Turn on VCR
Press [POWER] on the Remote.
●
The code transmitted from the Remote blinks
for a few seconds on the front display panel.
●
After the code disappears on the front display
panel, make sure that the VCR is turned on by
pressing [POWER] on the Remote.
To control four VCRs with the same Remote
You can control four JVC VCRs by switching the remote
control code for the Remote between A,B, C and D
(
step
2
), keeping four VCRs to different control
codes.
●
Press the ‘Number’ key [1] for A code control signals,
[2] for B code control signals, [3] for C code control
signals and [4] for D code control signals. (To change
only the remote control code for the Remote, DO NOT
perform steps
3
to
5
.)
Changing
Remote Control
Code
(Ex.) To set Remote to B code:
Press in succession
Hold
down
Release
NOTE:
When “POWER SAVE MODE” is set to “ON”, you can not
change the remote control code. Before changing the code, set
“POWER SAVE MODE” to “OFF” (
pg. 38).
1
2
3
4
5
6
7
8
0
9
VCR
TV
CABLE
/DBS
3 5
2
-
3
2
-
2
2
-
1
,
3
1
IN F-1
+
[POWER]
[PLAY (
3
)]
A/B/C/D
STOP
MULTI-BRAND REMOTE CONTROL (cont.)