Other Functions
Changing display information
Each time you press
DISPLAY
, the display
panel shows the time counter and the clock
time alternatively.
• When
DISPLAY
on the Remote is pressed,
time counter will appear on the TV screen.
To reset the time counter, press
C. RESET
on the Remote.
IF THE PROGRAM OVERLAPS ANOTHER
8 : 00
11 : 00
9 : 00
10 : 00
Program 1
Prog.1
Deleted Parts
Non Recorded Portion Parts
Prog.2
Prog.3
Program 2
Program 3
Recording
Control Settings
NOTES: •
The everyday/every week recording can be made
continuously until the recording is canceled or
the tape reaches the end.
•
During timer recording, the automatic rewinding
mechanism does not function.
NOTE:
Do not overlap programs as portions of the
conflicting programs will be lost. The first
recording time has priority over the next recording
time as shown in the diagram.
– Timer Recordings –
BLUE BACK — ON/OFF
When this function is set to “ON”, the TV screen becomes all
blue in the following case:
When receiving a channel not in use.
Press
MENU
on the remote. Press
SET –/+
to select
“SYSTEM SETUP”.
Press
SET –/+
to select “NO NOISE BACKGROUND”.
Press
ENTER
to select “ON”.
Press
MENU
to return to normal screen.
1
2
4
STEREO RECORDING AND PLAYBACK
When a MTS STEREO broadcast is
received, the STEREO will appear on the
screen for about 4 seconds and the
program can be viewed or recorded in
stereo.
The Hi-Fi STEREO recording procedure
is the same as for normal recordings.
NOTE:
When using a CATV system, stereo TV programs may be
transmitted over a mono cable channel. In this case the word
"STEREO" will not appear and the sound will be in mono.
OUTPUT SELECTION
The VHS Hi-Fi audio system permits high fidelity recording of
MTS STEREO TV broadcasts.
When viewing an MTS STEREO TV program, or playing a
prerecorded VHS Hi-Fi STEREO videotape, press
A.MONITOR
to
select how the audio will be heard through the speakers. Normally
set to the Hi-Fi STEREO position, this button can be set to the
MONO position if the stereo broadcast or videotape audio is of
poor quality. The "R" and "L" positions allow the audio from the
Right or Left Hi-Fi channel to be heard over both TV speakers.
This button has no effect when viewing a MONO videotape or TV
program. Each time when you press the button, OUTPUT
SELECTION display appears on the screen for several seconds.
Refer to the chart below.
RECORDING STEREO BROADCASTS
STEREO
NOTES: •
When playing back a tape that is not recorded in
Hi-Fi stereo mode, the audio will automatically be
monaural.
•
When listening to a VHS Hi-Fi video tape or MTS
broadcast through the VHF/UHF jack (Audio/
Video cord not connected), the sound will be
monaural.
OUTPUT
SELECTION
STEREO
L ch
R ch
MONO
SOUND HEARD ON BOTH
SPEAKERS
STEREO
LEFT CHANNEL AUDIO
RIGHT CHANNEL AUDIO
MONO
3
4F90201A/P08-Back
11/15/02, 03:56 PM
11
