EN
19
ShowView
Timer
Recording
SET TAPE SPEED
4
Press SP/LP (
) to set the tape speed.
RETURN TO NORMAL
DISPLAY
5
Press OK.
●
Repeat steps 1–5 for each additional programme.
ENGAGE RECORDER’S
TIMER MODE
6
Press TIMER.
NOTE:
For safety, your recorder disables all other functions while in the
Timer mode. If you want to use the recorder but its Timer mode
is engaged, press TIMER and all other functions are operable.
To re-engage the timer, press TIMER.
To Delay The Stop Time . . .
. . . press ADD TIME (NUMBER key “5”) after pressing OK in
step 3. Each time you press, the Stop time is delayed by 5
minutes (meaning that 5 minutes of recording time is
added). You can easily compensate for anticipated
programme schedule delays this way.
To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (NUMBER key
“9”) for weekly serials or DAILY (NUMBER key “8”) for
daily serials (Monday–Friday). “W” or “D” appears on the
front display panel.
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, “FULL” appears on the front display panel. To record the
extra programme, you must first cancel any unnecessary
programmes (
Z
pg. 21).
ACCESS TIMER PROGRAM-
MING DISPLAY
1
Press PROG.
ENTER SHOWVIEW
NUMBER
2
Press the NUMBER keys to enter the ShowView number
of a programme you wish to record.
●
If you make a mistake, press CANCEL and then input
the correct number.
ACCESS PROGRAMME
DISPLAY
3
Press OK, and the Programme display appears.
Press PROG. CHECK to confirm the date and the
channel position.
●
If the number you entered is invalid, “Err”(or)
appears. Press CANCEL and input a valid ShowView
number.
●
If you’re not receiving PDC/VPS, press NUMBER key
“7” to set
to “OFF” so that the indicator disap-
pears. (
Z
pg. 21).
SP
Start time
≠
Stop time
≠
SP
M
D
Day
≠
Month
≠
Channel position
≠
Before performing ShowView Timer Recording, see “Informa-
tion on ShowView” on page 17.
Before performing the following steps, insert a cassette with the
safety tab in place. The recorder power will come on automati-
cally.
To Satellite Tuner Users
When timer-recording a satellite programme using
ShowView, after performing steps 1 – 6, set the satellite
tuner to the appropriate channel before the selected
programme begins. Then set the satellite tuner’s timer. If the
tuner doesn’t have a timer, leave the unit’s power turned on.
