EN
13
Index Search
Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE INDEX SEARCH
1
Press
PUSH JOG
or on the remote control. “
™
1” or “
£
1” is displayed on screen and search begins
in the corresponding direction.
●
To access index codes 2 through 9, press
PUSH JOG
or repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press
PUSH JOG
twice.
To locate the beginning of D from the current
position, press
PUSH JOG
once.
●
When the specified index code is located, playback
begins automatically.
%
fi
fi
%
fi
%
Current position
A
B
C
D
E
F
–2
–1
1
2
3
%
%
Index number
Next Function Memory
You can set your recorder's power to go off automatically after
the tape is fully rewound.
Before starting, make sure the
recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press
REW
, then press
within 2 seconds.
Instant ReView
Simply by pressing a single button, the recorder power comes
on, rewinds, and begins playback of the last timer-recorded
programme. If you have several programmes recorded, you can
easily access any of them.
NOTE:
Before starting, make sure that the recorder is off and that the
Timer mode is disengaged.
ACTIVATE INSTANT
REVIEW
1
Press
REVIEW
. The recorder power comes on and the
recorder searches for the index code indicating the start
of the last timer-recorded programme. Once it’s found,
playback begins automatically.
●
The front display panel tells you how many
programmes have been recorded. If you have, for
example, 3 programmes, “REVIEW” and "3" appear
and blink. To watch the first of the 3 programmes,
press
REVIEW
three times. The recorder searches and
begins playback automatically. You can access a
programme as far as 9 index codes away from the
current tape position.
NOTE:
Instant ReView is not possible while the recorder is in the Timer
mode.
£
2
Tape Position Indicator
The tape position indicator
appears on screen when, from
the Stop mode, you press
FF
,
REW
or perform an Index
Search. The position of “
5
” in
relation to “0” (beginning) or
“+” (end) shows you where you
are on the tape.
”O.S.D.” (
Z
pg. 8) must be
set to “ON”, or the indicator
will not appear.
NOTE:
Depending on the type of tape used, there may be times when
the indication is not correct.
3
1:23:45
0
+
+
+
Beginning
End
