10
1
2
4
5
3
6
8
0
7
9
SELECT D.S.T. MODE
6
You have three choices:
a–Select “AUTO” and the
adjustment to your VCR’s
clock will be made
according to the incoming
signal from the host
channel.
b–Select “ON” and the
adjustment will be made
based on the clock itself.
c–Select “OFF” if Daylight Saving Time doesn’t apply to
you.
Place the arrow next to your choice by pressing
CH
5∞
or SHUTTLE PLUS
5∞
, then press MENU and
the Semi-Auto Clock Set screen reappears.
D.S.T. SELECT
=
AUTO
ON
OFF
PRESS (
5
,
∞
) TO SELECT
PRESS (MENU) TO END
2
2
q
5
/
8
6
CH
MENU
OK
CH
OK
MENU
NUMBER
INITIAL SETTINGS (cont.)
SHUTTLE PLUS
IMPORTANT
After performing the Semi-Auto clock set procedure, make
sure that the VCR is off before the next hour so that the clock
can be set. (The clock is automatically adjusted on the hour
except at 11:00 PM, midnight, 1:00 AM and 2:00 AM.)
Manual
SELECT MODE
2
At the Override Auto Clock Set screen, place the
arrow next to “MANUAL CLOCK SET” by pressing
CH
▲▼
or SHUTTLE PLUS
5∞
, then press OK.
SET DATE, TIME AND D.S.T.
3
Press the appropriate
NUMBER keys to set the
date and time (if only 1
digit, press "0" first), and
press CH
▲▼
or SHUTTLE
PLUS
5∞
to set AM/PM
and D.S.T. (Daylight
Saving Time) to “ON”
(automatic adjustment
based on VCR’s clock) or “OFF” (if D.S.T. doesn’t apply
to you).
Press OK after AM/PM and D.S.T. settings, and when
you’re finished with this screen, press MENU to start
the clock.
NOTE:
CH
▲▼
and SHUTTLE PLUS
▲▼
can be used to
perform all operations. (In this case, press OK after each
setting.)
MAKE CORRECTIONS
4
To change any of the settings, press OK or SHUTTLE
PLUS
™£
until the item you want to change
blinks, then set as in step 3.
MANUAL CLOCK SET
DATE 1/ 1/96 MON
TIME – – : – – AM
D.S.T. ON
PRESS NUMBER KEY(0-9)
OR (
5
,
∞
), THEN (OK)
PRESS (MENU) TO END
Summary of Contents for HR-J630U
Page 47: ...47 ...
