JVC HR-J668EU Instructions Manual Download

Page: 5 / 56

CONFIRM/SET VIDEO CHANNEL

If you have connected the video recorder to your TV

via an RF cable only (RF connection)

The channel that is shown on the display panel is your

Video Channel.

To view picture signals from the video recorder, set

your TV to the Video Channel. — Refer to the
instructions supplied with your TV set for how to do
this.

●

If you have selected MAGYARORSZAG (36), CESKA
REPUBLIKA (42), POLSKA (48) or OTHER EASTERN
EUROPE (EE) in step 2 on page 4, "2OUT" appears in
stead of "1OUT".

If you have connected the video recorder to your TV

via both an RF cable and a 21-pin SCART cable (AV
connection)

You do not need the video channel so you have to set

the video channel to off.

Press TV PROG – until the display panel shows

"1OUT– –" to set the Video Channel to off.

To view picture signals from the video recorder, set

your TV to its AV mode. — Refer to the instructions
supplied with your TV set for how to do this.

FINISH AUTO SET UP

Press OK and refer to page 7 to check the results.

●

If "– –:– –" appears on the display panel, refer to
page 7.

SELECT LANGUAGE

Press OK. The Language Set display appears on the
front display panel and/or on the screen.

If you are referring to the front display panel

Press

%fi

to select your language code.

If you are referring to
the on-screen display

Press

%fi

to move the

highlight bar (pointer) to
the language of your
choice.

PERFORM AUTO SET UP

Press OK.

If you are referring to the front display panel

Press

%fi

to select "Auto" and press OK or

If you are referring to the on-screen display

Press

%fi

to move the

highlight bar (pointer) to
"AUTO SET" and press OK
or

"Auto" blinks on the display panel; do NOT press
any button on the recorder or remote control until
the display panel shows either the display as
illustrated in step 5 or "– –:– –".

●

If you are using the on-
screen display, the
AUTO SET screen will
appear. As Auto Set Up
progresses, the " "
mark on the screen
moves from left to
right.

NOTES:

●

Auto channel set function takes place first; it assigns automati-
cally all receivable stations in your area.

●

Auto clock set function sets the clock automatically by
reading the clock setting data from a station transmitting a
PDC signal while auto channel set is being performed.

●

During auto channel set, the recorder recognizes each station
name of the detected stations and stores them in the
recorder's memory, then automatically sets S

HOW

IEW

assigned Guide Program number for those stations according
to the broadcast area.

●

In the area where no TV station transmits a PDC signal, the
recorder can perform neither auto clock set nor auto Guide
Program number set.

●

For RF connection users: The video recorder detects the
channels which are not occupied by local stations and selects
one channel automatically for your Video Channel that is
located in the middle of more than 5 vacant channels.

●

If there is a power cut, or if you press

or MENU while Auto

Set Up is in progress, Auto Set Up will be interrupted; be sure
to turn off the recorder power once and try again from step 1.

●

Auto clock may not function properly depending on the
reception condition.

AUTO SET

PLEASE WAIT

[MENU] : EXIT

Beginning

End

(Ex.) DEUTSCH is selected for SUISSE