advanced features
52
Editing Using Another VCR
connect up
Connect the player’s 21-pin SCART connector to the recorder’s
21-pin SCART connector as illustrated.
A
When using your VCR as the player ...
... connect its
AV1 (L-1) IN/OUT
connector to another VCR.
B
When using your VCR as the recorder ...
... connect its
AV2 (L-2) IN/DECODER
or
AV1 (L-1) IN/OUT
connector to another
VCR.
set vcr’s input mode
The recording VCR mode must be set to
AUX
. If this
VCR is the recorder, press
AUX
and/or
PR
to select
L-1
(if you’ve used the
AV1 (L-1)
IN/OUT
connector) or
L-2
(if you’ve used the
AV2 (L-2) IN/DECODER
connector). If
this VCR is the player, set
O.S.D.
to
OFF
. (
pg. 55)
• When using the
AV2 (L-2) IN/DECODER
connector, set
L-2 SELECT
to the
appropriate mode. (
pg. 51)
set edit mode
See
Picture Control
on page 33
.
start source vcr
Engage its
PLAY
mode.
start recording vcr
Engage its
RECORD
mode.
NOTES:
• All necessary cables can be obtained from your dealer.
• For Y/C signal input/output, be sure to use a 21-pin SCART cable that is
compatible with the Y/C signal.
• When you set
PICTURE CONTROL
to
EDIT
to dub tapes (
pg. 33), be sure to
select
AUTO
(or
NORM
when
B.E.S.T.
is set to
OFF
) after you finish dubbing the
tapes.
• If you are using another VCR with S-Video and Audio output connectors,
You can use you VCR as the recorder using an optional S-Video cable and
audio cable. Connect its front panel
S-VIDEO
and
AUDIO
input connectors to
the source VCR’s S-Video and Audio output connectors. Then, set the VCR’s
input mode to
S-1
.
