basic features
19
Notes on Recording
When using both the RF and SCART connections, you can switch between TV
and VCR by pressing the
TV/VCR
button on the Remote Control.
If the tape reaches its end during recording, the recording stops and “
U
” and
“
,
” on the display panel blink. Press
S
/
0
on the VCR or on the Remote
Control to eject the tape or press
<
to rewind the tape.
Display Tape Remaining Time
Press the
b
button so that the tape remaining time is shown on the TV
screen with ‘REMAIN’ indication. The on-screen information will disappear
after about 5 seconds.
non-standard tapes
Sometimes, a tape will not conform to the standards
accepted by this VCR. In such cases the tape remaining time may not appear
immediately, be incorrect or simply show as ‘– – : – –’.
Change Display Information
By pressing the
b
button repeatedly, you can change the display on the VCR
between the clock time and the preset position. The preset position cannot be
shown during playback.
Resetting the Counter
Press the
b
button so that the counter display appears on the TV screen.
While the display is shown, press the
0000
button. You can reset the counter to
‘0:00:00’ before starting playback or recording.
Record a Programme While Watching Another
Once you have started recording all you need to do is use the controls on your
TV set to tune to a different programme. The programme set using
PR
+
/
–
button on the Remote Control or the
JOG Dial
on the VCR is the one which will
be recorded.
HR-S6975EK-EN/p13-20
3/12/04, 02:16 PM
19
