welcome to jvc
14
Check the Results
When
Auto Setup
or
Preset Download
finishes, you will see one of the three
following examples on the VCR display panel:
The Preset Positions and the Clock have been set successfully
Go straight to
Step 3
(20:00 used as example only).
The Preset Positions have been set successfully but the Clock has not
Perform Clock Set on page 66.
Go to
Step 3
.
Neither the Preset Positions or the Clock have been set successfully
Make sure the cables are connected properly to the VCR and turn
the VCR off and then on again. Try
Auto Set Up
or
Preset Download
again.
Finish Off
Select the Video channel or AV mode, then make sure that all necessary stations
have been stored in the VCR’s memory by using the
PR +
or
-
buttons.
If station names (ID —
pg. 64) have also been stored in the VCR’s memory, the
station name will be displayed at the top left corner of the TV screen for about 5
seconds each time you select a different channel via the VCR.
The VCR is now set up.
You can now use it to play and record.
IMPORTANT
•
re-running setup
Auto Setup or Preset Download may not behave as
described if it has already been run on the VCR. This is because some of the
information gathered on the first Auto Setup or Preset Download is retained in
memory and that part of the process may be skipped by the VCR.
•
bad reception
In certain reception conditions, station names may not be
stored correctly, and
Guide Program Numbers
may not be set properly. If this
happens, when you timer-record a TV programme using the VIDEO Plus+
system, the VCR will record a TV programme of a different station. When
programming the timer using the VIDEO Plus+ system, be sure to check that
the preset position corresponding to the broadcasting station you wish to
record has been selected (
pg. 23,
VIDEO Plus+ Timer Programming
).
•
duplic ate stations
You may be able to receive the same station from two
different transmitters in which case Auto Setup will detect and store both. It is
normal for one transmitter to give you a better quality picture than the other; to
delete those stations which have a poor picture
Delete A Channel
on page 62.
•
manual station setting
If any of the above problems occur, refer to
pages 62 – 63 to input station names (
Change Station Name
). You can also
change station preset positions (
Change Station Preset Position
).
•
rf connections
In certain reception conditions, the Video Channel may not
be set correctly and interference may appear in the TV picture while the VCR’s
power is on. Set your Video Channel manually. (
pg. 59,
Video Channel Set
)
IF YOU HAVE ANY DIFFICULTY WITH THE ABOVE PROCEDURES CALL THE JVC
CUSTOMER SERVICE HOT LINE ON 0870 330 5000
TV PR +
TV PR –
T
V
–
TV
+
0000
STOP
FIN
MENU
OK
TV/VCR
DAILY/QTDN.
VPS/PDC
AUX
WEEKLY/HEBDO
PROG
30 SEC
– –:– –
AUDIO
1
2
3
4
6
5
7
8
9
0
DATE
START
DEBUT
PR
4
1
3
ENTER/ENTR
EE
EXPRESS
TV
?
2
/
LP00000-000
VCR/ TV
ABC
. , /
DEF
JKL
GHI
MNO
TUV
PQRS
WXYZ
OK
3
/
TV PR +
TV PR –
T
V
–
TV
+
MEN
U
ENTER/ENTR
EE
HR-S7965EK-EN/p08-14
4/19/03, 01:36 PM
14
