60
EN
SUBSIDIARY SETTINGS (cont.)
SELECT STATION NAME
CHARACTER
1
Press
#
until the first letter
of the station name begins
blinking.
ENTER NEW CHARACTER
2
Press
%fi
to cycle through the characters (A–Z, 0–9, –,
*
, +, (space) ) and stop when the desired character
is indicated, then press
#
to enter. Enter the remaining
characters the same way (maximum of 4).
After entering all characters, press OK.
●
The Confirmation screen appears.
●
If you make a mistake, press
@
until the incorrect
character begins blinking. Then enter the correct
character by pressing
%fi
.
CLOSE CONFIRMATION
SCREEN
3
Press MENU.
Set Stations (B)
Perform steps 1 and 2 of "Storing Channels Manually" on
page 58 to access the Confirmation screen before continuing.
SELECT ITEM
1
Press
%fi
@ #
until the item you want begins blinking.
ACCESS MANUAL
CHANNEL SET SCREEN
2
Press OK twice.
SELECT NEW STATION
3
Press
#
until the station
name (ID) begins blinking,
then press
%fi
until the
new station’s name (ID)
you want to store begins
blinking.
Registered station names
(
Z
pg. 61) appear as you
press
%fi
.
SWITCH STATIONS
4
Press OK.
●
The Confirmation screen appears.
●
Repeat steps 1 through 4 as necessary.
CLOSE CONFIRMATION
SCREEN
5
Press MENU.
Set Stations (A)
Set station names that are registered in your recorder.
Perform steps 1 and 2 of "Storing Channels Manually" on
page 58 to access the Confirmation screen and then perform
step 1 and 2 of "Set Stations (A)" on the left before continuing.
Set station names other than the ones registered in your recorder.
PR CH
ID
FINE DECODER
06 CH45 – – – – +/–
OFF
[
5∞
] : CHANGE ID
[
] : CURSOR
+=
: OK
[MENU] : EXIT
∞
∞
PR CH
ID
FINE DECODER
06 CH45 ARD
+/–
OFF
[
5∞
] : A-Z, 0-9
[
] : CURSOR
+=
: OK
[MENU] : EXIT
∞
∞
Summary of Contents for HR-S8600EK
Page 75: ...EN 75 MEMO ...
