Masterpage:Right
EN
59
Filename [HRS8960E4-EN.fm]
Page 59
May 1, 2003 2:39 am
Manual Channel Set
Store channels that were not stored during Auto Set Up
(
pg. 14) or Auto Channel Set
A
Access the Main Menu screen.
Press
MENU
.
B
Access the Confirmation screen.
Press
r t
to move the highlight bar (pointer) to
“MANUAL CH SET”, then press
OK
or
e
. The
Confirmation screen appears.
C
Select the channel position.
D
Select the band.
E
Input the channel.
Press the
number keys
to input the channel number you
want to store.
●
Input “0” before any single number entries.
●
To input the registered station name (ID –
pg. 62), press
e
until “– – – –” (ID setting) begins blinking, then press
r t
.
●
For fine tuning adjustment, press
e
until “+/–” begins blinking,
then press
r t
. While tuning, “+” or “–” appears.
●
When storing a channel that sends scrambled broadcasts,
press
e
until “OFF” (Decoder setting) blinks, then press
r t
to set “DECODER” to “ON” (“OFF” is the default setting).
●
When “L-2 SELECT” is set to “A/V” or “SAT”, the “DECODER”
setting cannot be changed (
F
Enter new channel information.
Press
OK
and the Confirmation screen appears.
●
Repeat steps
3
–
6
as necessary.
G
Close the Confirmation screen.
Press
MENU
.
●
To change positions, see “Change Station Channel Position”
(
●
If you wish to set station names other than the ones registered
in your recorder, see “Set Stations (B)” (
Press
r t
w
e
until an open
position in which you want to
store a channel begins
blinking, then press
OK
. The
Manual Channel Set screen
appears.
(Example) To store in position 12.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
Press
r t
to change the band
between CH (regular) and CC
(cable), then press
e
.
HRS8960E1-EN.book Page 59 Thursday, May 1, 2003 2:40 AM
