EN
73
This Remote is capable of transmitting two control
codes; one set to respond to A code control signals and
another set to respond to B code control signals.
This Remote control is preset to send A code signals
because your VCR is initially set to respond to A code
signals. You can easily modify your VCR and the Remote
to respond to B code signals.
When using two JVC VCRs, set two VCRs and their
Remotes to different codes, so that you can operate these
VCRs separately.
1
Unplug VCR
Unplug the AC power cord from the AC outlet.
2
Set remote operation mode
Set the
VCR/TV/CABLE/DBS
selector to “VCR”.
3
Set remote control code for Remote
1
Press and hold
A/B
.
2
Press the
Number
key “
2
”.
3
Press
STOP
(
7
), and release
A/B
.
●
The Remote now can transmit B code control
signals.
4
Plug in VCR
Plug the AC power cord back into an AC outlet.
5
Turn on VCR
Press
POWER
on the Remote.
●
The VCR now responds to B code control
signals.
●
To set the Remote and the VCR back to A code
control signals, repeat the same procedure as
shown above except pressing the
Number
key
“
1
” in step
3
.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote
control code for the Remote between A and B (
墌
step
3
), keeping two VCRs to different control codes.
●
Press the
Number
key “
1
” for A code control signals
and the
Number
key “
2
” for B code control signals. (To
change only the remote control code for the Remote,
DO NOT perform steps
1
,
4
, and
5
.)
Changing
Remote Control
Code
(Ex.) To set Remote to B code:
Press in succession
Hold
down
Release
STOP
ABC
A/B
2
1
2
3
4
5
6
7
8
9
0
VCR TV CABLE/DBS
3
–
2
3
–
1
,
3
5
2
3
–
3
HR-S9800U-EN64-73
00.3.29, 7:30 PM
73
Summary of Contents for HR-S9800U
Page 85: ...EN 85 MEMO ...
Page 86: ...86 EN MEMO cont ...
Page 87: ...EN 87 ...
Page 88: ...HR S9800U COPYRIGHT 2000 VICTOR COMPANY OF JAPAN LTD Printed in Malaysia 0400 IYV MW PJ U ...
