EN
45
1
2
3
4
5
6
7
8
9
0
2
4
1
3
UNPLUG VCR'S POWER
CORD
1
Unplug from the AC outlet.
SET REMOTE CONTROL
CODE
2
While holding down
A/B
on the remote control, press
the
NUMBER
key "2" and then press
STOP
.
PLUG IN POWER CORD
3
Plug back in to the AC outlet.
TURN VCR POWER ON
4
Press
POWER
on the remote.
The VCR will now respond only to B-code commands.
To set the VCR back to respond to A code signals, repeat the
same procedure as shown above except pressing
NUMBER
key
"1" instead of "2" in step
2
.
You can control two VCRs with the same remote control by
switching the remote's code between A and B (
墌
Step
2
).
Control Two JVC VCRs
The remote control is capable of controlling two JVC VCRs
independently; one set to respond to your remote control's
A
code control signals and another set to respond to
B
code
control signals. The remote control is preset to send
A
code
signals because your VCR is initially set to respond to
A
code
signals. You can easily modify your VCR to respond to
B
code
signals.
A/B
POWER
NUMBER "1"
STOP
NUMBER "2"
TIMER
TURN VCR POWER ON
1
Press
POWER
.
ENGAGE CHILD LOCK
2
Press and hold
POWER
on the remote control until the
Child Lock indicator ("—") appears on the front display
panel.
●
Power turns OFF and the VCR cannot be turned on
from the
POWER
button on the front panel.
●
To cancel Child Lock, press and hold
POWER
on the
remote until the VCR turns on. During timer record-
ing, pressing
TIMER
also cancels Child Lock.
NOTES:
●
When Child Lock is engaged, make sure to keep the remote
control out of the reach of children.
●
Timer recording of programs that were previously set can be
performed while the Child Lock is engaged. The feature
remains in effect after the recording is finished.
Child Lock
This feature allows you to prevent the operation of the VCR.
(Ex.) To set remote control B code:
MBR SET
A/B
2
STOP
Press in succession
Hold
down
Release
