EN
21
1
2
3
4
5
6
7
8
9
0
2
4
1
3
OK
NUMBER
SHUTTLE PLUS
ACCESS DBS RECEIVER
BRAND SET SCREEN
7
Press
OK.
SET DBS RECEIVER BRAND
8
Press the appropriate
NUMBER
keys to enter the
DBS Receiver Code from
the following list, then
press
OK
.
●
After
OK
is pressed, the program currently received
through the DBS receiver will appear for about 10
seconds.
●
If the DBS receiver's channel changes as follows,
setting is complete. Press
OK
and "DBS RECEIVER
CONTROL IS ON" appears on the screen for about 5
seconds, then it returns to the normal screen.
JVC
[
100
ECHOSTAR
[
100
PRIMESTAR
[
55
SONY
[
205
RCA
[
205
●
If the DBS receiver's channel does not change as
shown above, press
CH
5∞
or
SHUTTLE PLUS
%fi
to move the highlight bar (arrow) to "NO", then press
OK
. Re-enter the correct code.
BRAND
CODE
JVC (DISH Network)
51
ECHOSTAR (DISH Network)
51
PRIMESTAR
50
SONY (DSS)
41
RCA (DSS)
40
NOTES:
●
It is possible that the Controller will not work with all types of
DBS receiver.
●
If your DBS receiver doesn’t respond to the code, you can’t
use the Controller to change satellite channels. In this case,
make sure to leave the DBS receiver turned on and tuned to
the proper channel before the scheduled start of timer
recording.
●
The VCR can only change the satellite channel through the
Controller during timer recording.
●
If your DBS receiver is one that can’t be operated with a
remote control (because it has no remote sensor), you can’t
use the Controller to change its channels. Make sure to leave
the DBS receiver turned on and tuned to the proper channel
before the scheduled start of timer recording.
●
For customers in U.S.A.:
If you are unable to set the Control-
ler, please contact JVC toll free at 1-800-252-5722.
DBS RECEIVER BRAND SET
4 0
PRESS NUMBER KEY (0–9)
THEN (OK) TO TEST
PRESS (MENU) TO END
OK
CH
40
Summary of Contents for HR-VP674U
Page 63: ...EN 63 MEMO ...
