EN
41
This Remote is capable of transmitting two control
codes; one set to respond to A code control signals and
another set to respond to B code control signals.
This Remote control is preset to send A code signals
because your VCR is initially set to respond to A code
signals. You can easily modify your VCR and the Remote
to respond to B code signals.
When using two JVC VCRs, set two VCRs and their
Remotes to different codes, so that you can operate these
VCRs separately.
1
Unplug VCR
Unplug the AC power cord from the AC outlet.
2
Set remote control code for Remote
1
Press and hold A/B.
2
Press the Number key “2”.
3
Press OK, and release A/B.
●
The Remote now can transmit B code control
signals.
3
Plug in VCR
Plug the AC power cord back into an AC outlet.
4
Turn on VCR
Press POWER on the Remote.
●
The VCR now responds to B code control
signals.
●
To set the Remote and the VCR back to A code
control signals, repeat the same procedure as
shown above except pressing the Number key
“1” in step
2
.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote
control code for the Remote between A and B (
Z
step
2
), keeping two VCRs to different control codes.
●
Press the Number key “1” for A code control signals
and the Number key “2” for B code control signals. (To
change only the remote control code for the Remote,
DO NOT perform steps
1
,
3
, and
4
.)
Changing
Remote Control
Code
(Ex.) To set Remote to B code:
MBR SET
A/B
2
OK
3
ENTER/O
SD
Press in succession
Hold
down
Release
1
2
3
4
5
6
7
8
9
0
2
4
1
3
2
–
2
,
3
2
–
1
4
2
–
3
