28
Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Symptom
DVD or VCP do not
work properly.
No power.
The power is on, but
the DVD player does
not work.
No picture.
No sound.
The picture is poor.
The DVD player does
not start playback.
The remote control
does not work properly.
Video tape cannot be
inserted.
No Hi-Fi sound
Cause
DVD or VCP button is not switched
properly.
The power cord is disconnected.
No disc is inserted.
The TV is not set to receive DVD signal
output.
The equipment connected with the
audio cable is not set to receive DVD
signal output.
The audio cables are not connected
securely.
The power of the equipment connected
with the audio cable is turned off.
The Digital Audio Output is set to the
wrong position.
The disc is dirty.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the guide.
The disc is dirty.
The Rating level is set.
There is an obstacle in the path of the
remote control and this unit.
The batteries in the remote control are
exhausted.
Is the cassette compartment empty?
Audio mode is not set properly.
Correction
Press
DVD
or
VCP
on the remote con-
trol, or
DVD/VCP
on the front panel to
switch the control.
Plug the power cord into the wall outlet
securely.
Insert a disc. (Check that the DVD or,
audio CD indicator in the display
window is lit.)
Select the appropriate video input mode
on the TV so the picture from the DVD
player appears on the TV screen.
Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD player.
Connect the audio cable into the jacks
securely.
Turn on the equipment connected with
the audio cable.
Set the Digital Audio Output to the
correct position, then turn on the DVD
player again by pressing
POWER
.
Clean the disc.
Insert a playable disc. (Check the disc
type, color system and Regional code.)
Place the disc with the playback side
down.
Place the disc on the disc tray correctly
inside the guide.
Clean the disc.
Cancel the Rating function or change
the rating level.
Remove the obstacle.
Replace the batteries with new ones.
Eject the tape in.
Select
“
HI-FI
”
by repeatedly pressing
A. MONITOR
on the remote control.
Video Head Cleaning
Whenever a video cassette is inserted into or ejected from your VCP, the video head is automatically cleaned. This
should mean that additional head cleaning should not be necessary. However dirt accumulating on the head after a
long period of time can cause the playback picture to become blurred or broken up.
High quality video cassette tapes will not normally deposit dirt onto the video head, but old or damaged tapes might.
