13
TEST
Setting the TV to the AV-Channel
We recommend that television and DVD/VCR are being connected with a scart cable.
In this case, the setting of AV-channel is not necessary. Picture and sound of video cassette will be transmit-
ted to television through the scart cable automatically. Please read the next page.
•
•
Turn on the TV.
Make sure the power of DVD/VCR has been
turned off
.
Press the DVD/VCR’s
(not the one on your remote
control) and keep pressing it until the display shows rF:.
The number next to rF: is the channel in UHF-band to
which you must tune your TV-set.
If there is interference in the picture (you see 2 programs
simultaneously or what is called Ghosts), change the
sending channel in DVD/VCR. To do this, go back to the
step
1
. Use
PR
button on the DVD/VCR to change the
number next to the rF:. Then return to step
2
and tune the
television newly.
1
3
In case of no scart cable connection,
you must set the television to the AV-
channel. Pay attention to the following
notice:
A built-in TV-broadcast in DVD/VCR can
do the video playback through the sup-
plied antenna cable. This broadcast is
sent on UHF, channel 36. To receive this
broadcast, you must tune your televi-
sion to channel 36 in UHF-band.(see
step 2)
In case a broadcast has already sent
to channel 36 in your area or you con-
nect a additional equipment (e.g. Sat-
ellite receiver) with a coaxial cable
(without a scart cable), you must tune
the sending channel in DVD/VCR (see
step 3). In your television store the both
equipment (the DVD/VCR and the sat-
ellite receiver) to 2 different program
positions.
Example: Your satellite receiver is sent
to channel 36. You tune the DVD/VCR
to channel 40 (see step 3).
(If your DVD/VCR is also sent to chan-
nel 36, the interference will occur.)
In your television store the channel 36
to e.g. program position 3 and store the
channel 40 to e.g. program position 4.
Note that the program position 4 must
be suitable for video-playback espe-
cially. Please see the owner's manual
for your television. If the playback pic-
ture is often distored, you must select
the other program position for DVD/
VCR.
Preparation
If you want to use your DVD/VCR, switch
your television to this program position.
Switch your television to the program position on which
the video playback is seen. Start the channel search of
your television until “TEST” appears. Store this tuning in
television like also the case of the reception for normal
television-channels you would store.
2
Press
button to turn off the DVD/VCR.
4
Note:
If you receive one TV-program on channel 35, 36 or 37, the interference can be occurred to the built-in TV
channel in DVD/VCR. If you use a scart cable for the transmission of picture and sound, you can cut off the
built-in TV-program. Then the video playback through the supplied antenna cable is not possible any more.
Press
PR
repeatedly (at step 1) until OFF will appear.(OFF appears after 69 or before 23)
VCR
TEST
1,4
3
2A73501AE(12-15)
4/17/02, 8:22 PM
13
