Initial Setup
This TV has three color projection tubes: one for red, green, and blue. When mixed together in
the proper portions, the output of these three color tubes can produce any color. To produce
these colors, however, the beams must be precisely aligned over each other so that the colors
can be mixed. The produce of aligning these picture beams is called “convergence”.
Attention:
• Please have your TV on for at least 20 minutes before using this feature.
• This adjustment will be needed only when the colors of the characters/lines are separated
and lack in distinction. If not, please don’t perform the adjustment.
Colors may become separated after the TV has been moved, or
over a long period of time if regularly subjected to low levels of
vibrations. If the colors become separated, please perform the
adjustments below again.
In the beginning, please be sure to
perform AUTO convergence adjustment.
Press the M
ENU
button
π†
To CONVERGENCE
è
To Enter
π
†
To select “AUTO”
(The convergence adjustment will
start. It will take about 50 seconds).
When the adjustment is finished, it will return to what you
were watching.
Note:
• You can reset the adjustment if you do not like the results. See the next page.
• If you want to adjust it more, you can perform the manual color convergence adjustment.
See the next page.
• You can also access this feature by pressing the channel up and channel down buttons
simultaniously on the front panel of your TV.
36
Adjusting CRT Color Convergence
Auto
65,56,48WP74 English OK1
2/18/03, 1:46 PM
36
Summary of Contents for I Art PRO AV-48WP74
Page 58: ...Troubleshooting 58 ...
