(No.MA249)1-15
SECTION 4
ADJUSTMENT
4.1
Adjustment method
Test instruments required for adjustment
(1) Digital oscilloscope (100MHz)
(2) Electric voltmeter
(3) Digital tester
(4) Tracking offset meter
(5) Test Disc JVC :CTS-1000
(6) Extension cable for check
EXTSH002-22P
×
1
Standard volume position
Balance and Bass &Treble volume : lndication"0"
Loudness : OFF
Standard measuring conditions
Dummy load
Exclusive dummy load should be used for AM,and FM. For FM
dummy load,there is a loss of 6dB between SSG output and
antenna input.The loss of 6dB need not be considered since
direct reading of figures are applied in this working standard.
How to connect the extension cable for adjusting
Caution:
Be sure to attach the heat sink and rear bracket onto the power amplifier IC and regulator IC respectively, before supply the power.
If voltage is applied without attaching these parts, the power amplifier IC and regulator IC will be destroyed by heat.
Power supply voltage
DC14.4V(11 to 16V)
Load impedance
20K
Ω
(2 Speakers connection)
Output Level KD-ARXXX Line out 4.0V (Vol. MAX)
KD-GXXX
Line out 2.5V (Vol. MAX)
Side panel
EXTSH002-22P
Rear bracket
CN501
Summary of Contents for KD-AR870J
Page 23: ... No MA249 1 23 ...
Page 27: ... M E M O ...
Page 49: ... M E M O ...
Page 77: ...XXXXX 3 27 MEMO ...