(No.MA454<Rev.001>)1-15
(2) Remove the A worm gear, M connect gear and M wheel
gear by sequentially. (See Fig.16)
Fig.16
(3) Remove the two screws
G
attaching the Loading motor.
(Se Fig.17)
Fig.17
(4) When attaching the Loading motor, motor wire should arrange
to figure. (See Fig18.)
Fig.18
3.2.10 Removing the Roller assembly (See Fig.19)
(1) Remove the Slit washer.
(2) Remove the R middle gear.
(3) Remove the R connect gear.
(4) Snap off the part
a
of the Roller assembly.
(5) Lift up the part
b
of the Roller assembly, and then release
part
c
(When release part
c
, R collar R is easy to come off,
does not lose it).
CAUTION:
When reattach the Roller assembly, Middle gear should keep
direction and Slit washer should be change new part.
Fig.19
3.2.11 Removing the Roller (See Fig.20)
(1) Remove the Slit washer.
(2) Pull out the Roller shaft.
CAUTION:
When reattach the Roller shaft, Slit washer should be change
new part.
Fig.20
A worm gear
M connect gear
M wheel gear
G
Wire arrangement
Direction
Slit washer
R connect gear
R collar R
R middle gear
part
b
part
a
part
c
keep direction
slit
small side
keep direction
slit
Summary of Contents for KD-AVX55A
Page 31: ......
