English
INSTALLATION
The illustration above shows a typical installation. However, you
should make adjustments corresponding to your specific car.
A
Location of the unit
•
Mount this unit on a firm surface, such as in the trunk or under the
front seat.
•
When mounting the unit under the front seat, make sure that
adjusting the seat position will not catch any wire of the unit.
•
Since heat is generated in the unit, do not mount it near
inflammable objects.
•
Do not mount the unit in the places subject to heat: near a
radiator, in a glove compartment or in insulated areas such as
under a car mat that will prevent the unit from dissipating heat.
①
Under the front seat
②
Onto the trunk floor
B
Install the unit
•
When mounting this unit, be sure to use the provided screws.
•
If any other screws are used, there is a risk of loosening the unit or
damaging the parts under the car floor.
•
Before drilling holes in the trunk to install the unit, make sure that
there is a sufficient space under the trunk so that you do not drill
holes in the fuel tank, etc.
③
Provided screw Ø 4 × 20 mm (13/16 in.)
④
Drilled hole
TERMINAL CONNECTION
Use ring terminals (not provided) for secure connection.
INSTALLATION
TERMINAL CONNECTION
B5E-0089_DR3001D.indd 2
2015/12/03 10:20
