E-24
When shooting images of computer monitors or displays, horizontal bands will appear on the screen. To
eliminate the bands, it will be necessary to align the shutter speed with the scanning frequency of the
monitor.
4. Various Modes of Shooting
Shooting the Computer Monitor
“EXPOSURE” Screen
Computer Monitor
3. 4.
5. 6.
- - -
- - -
EXPOSURE
I R I S MODE
AUTO
ST E P
0 d B
S T EP
MA
L
A
U
N
NO
L
A
M
R
L EVE L
GA I N
E
L EV L
SHUT TER
L EVE L
ADVANCED EXPOSURE . .
BACK
PAGE
- - - - - -
- - -
- - -
EXPOSURE
I R I S MODE
AUTO
ST EP
0 d B
V. SCAN
1 / 5 0 s
MA
L
A
U
N
L EVE L
GA I N
E
L EV L
SHUT TER
L EVE L
ADVANCED EXPOSURE . .
BACK
PAGE
- - - - - -
Band
1.
Press the [MENU] button for 1-2 seconds.
The “MENU” screen will be displayed.
2.
Use the [
/
] buttons to select “EXPOSURE..”, then press
the [SET] button.
3.
Use the [
/
] buttons to select “SHUTTER”, then press the
[SET] button.
The set value starts blinking and adjustment is possible.
4.
Use the [
/
] buttons to set value to “V.SCAN”, then press
the [SET] button.
5.
Use the [
/
] buttons to select “LEVEL”, then press the [SET]
button.
6.
Use the [
/
] buttons to adjust the shutter speed. Pay atten-
tion to the screen
If black bands are visible : use the [
] button to lower the shut-
ter speed
If white bands are visible : use the [
] button to increase the
shutter speed
7.
When bands are decreased to the minimum, press the [SET]
button. This will be recorded in the memory of the unit.
8.
Press the [MENU] button for 1-2 seconds.
The normal screen will be displayed.
Note
Vertical scanning frequency may vary with computer types and there are cases when bands may not be fully
eliminated. In addition, frequency may also differ depending on the software used.
