E10
Part names and their functions (continued)
1. Introduction (continued)
쐎
MODE/SET button
●
[MODE]
Pressing this button each time will switch
between the REC (record)* and PLAY
(playback) modes.
* REC mode is the condition which the unit
has either captured an image or is ready
to write an image to the main unit memory.
Recording images to the main unit memory
(
page 36)
Playing back images from the memory
(
page 37)
●
[SET]
While the menu screen is being displayed,
use this button to select a submenu or
confirm a selected item or set value.
Setting in the menu screen (
page 46)
[Rear (continued)]
SEE INSTRUCTION MANUAL
POWER
DC IN
REMOTE
MONITOR
LENS
FREEZE
PLAY
SET
DOWN
AW/SEL
SEND
SCSI
UP
MENU
MODE
REC
ON 1 2 3 4
Ventilation hole
쐅
REC display lamp
This lamp lights when in the REC* mode.
During FREEZE, this display lamp will flash.
* During the REC mode, camera images
are outputted to the MONITOR terminal.
Pressing the FREEZE button at this time
will save the image to the main unit
memory.
Recording images to the main unit memory
(
page 36)
쐈
PLAY display lamp
This lamp lights when in the PLAY* mode.
* During the PLAY mode, images saved in
the main unit memory are played back
by outputting to the MONITOR terminal.
Playing back images from the memory
(
page 37)
MEMO
The default mode when the power is turned
on is REC.
If this button is pressed in the condition in
which there is no playback image stored in
the memory, “NO PICTURE” is displayed.
