JVC KY-PZ400NBE, Instructions Manual

Installing the Camera on a

Desktop

Configure the video format settings using the

SYSTEM SELECT switch before installing.

0

Place the camera on a flat surface.

0

Be sure to place the base of the camera

horizontally. The camera will not operate

properly if it is slanted.

Memo : 

0

The use of ceiling mount bracket is not required.

Caution : 

0

Do not move the camera while the power of the

system is on. Doing so may result in

malfunctions or accidents.

0

Do not hold the camera head while carrying the

camera.

Connect the cables after these procedures.

Attaching the Camera to a

Tripod

Configure the video format settings using the

SYSTEM SELECT switch before installing.

0

Attach a tripod using the screw hole at the

bottom of this product.

(1/4-20UNC, ISO1222 (6.35 

㎜

))

0

To prevent the camera recorder from falling off,

which may result in injuries or damages, read the

“INSTRUCTIONS” of the tripod to be used and

make sure that it is securely attached.

0

To ensure proper pan/tilt operation, set the

tripod such that the camera is parallel to the

horizontal surface.

Memo : 

0

The use of ceiling mount bracket is not required.

Caution : 

0

If the camera recorder exceeds the weight limit

of the tripod, do not mount it on the tripod.

0

Use the tripod on a stable surface.

0

Use screws with a screw length between 4.5 mm

and 7 mm.

0

Do not install the camera at a high location when

the camera is attached to a tripod.

Connect the cables after these procedures.

Connecting the Cables

1

Connect the cables

0

Connecting to an HDMI/SDI monitor allows

you to check the camera images.

0

To input or output the audio, connect the

audio cables respectively to the LINE IN/OUT

terminals.

2

Connect the LAN cable.

Caution : 

Connect to the LAN cable to devices (routers,

hubs, computers, etc.) that are certified under the

Telecommunications Business Act.

3

Connect the power cable.

0

To supply power from an AC adapter,

connect an AC adapter cable.

0

To supply power via PoE, do not connect the

AC adapter cable.

4

After the power turns on, the POWER lamp

lights up and initialization starts

The camera lens moves to both the horizontal

and vertical limit positions. Initialization is

complete after it has moved back to the front

view position.

Memo : 

0

Operation is possible when the light of the

STANDBY lamp has turned off.

0

If Preset 1 is preconfigured, the camera will

move to the Preset 1 position.

Caution : 

0

Do not supply power through the AC adapter

cable and LAN cable at the same time.

Warning

To supply power to this unit, use a DC 12 V or

PoE (IEEE802.3af) power. Make use of the

correct voltage.

Supplying a power beyond the rated value may

result in failures, smoke or fire. If the camera

breaks down, turn off the power and contact our

service center immediately.

When a power beyond the rated value is

supplied, the internal components may be

damaged even if no abnormality is found on the

appearance and operation of the camera.

Please contact our service center immediately

for servicing (charged separately).

Installing the Camera on a Desktop

23

Installation/Connection