17
a
Connect the AC adapter output cord to the [DC In]
terminal of this unit.
b
Attach the power cord to the AC adapter
c
Insert the power cord into the power outlet
●
The following message is displayed on the LCD for about 3 seconds.
Perform the following procedures to switch this unit to the operating mode
if the Status LED does not light up.
d
Turn on the power by pressing the Power/Standby
button on this unit
●
The Status LED lights up in red.
e
Turn on the power of the input source.
f
Press the [
H
/
I
] buttons to select the input source
●
The Status LED lights up in blue when signals are detected.
Turning on the power
Before plugging in the power cord, ensure that all devices have been connected.
f
d
a
c
b
JVC LD-HD1K
Powered by ABT
Precautions Against Fire and Electric Shock
●
When not using devices, remove the power plug from the wall outlet.
●
Do not use power cords for connection other than those supplied.
●
Do not use AC adapters for connection other than those supplied.
●
Do not use a power voltage different from that which is indicated.
●
Do not cut, tear or modify the power cords. Also, do not place a heavy object on, heat or stretch the power cords as this
may cause damage to the cords.
●
Do not modify or disassemble the AC adapter.
●
Do not use the supplied AC adapter on other devices.
●
Do not insert or pull out plugs with a wet hand.
●
Do not allow dirt or metal to adhere to the power plug.
●
When the electricity is turned on, do not cover the AC adapter with a rug or place it near equipment emitting heat, such
as heaters.
●
Do not use with the power plug and AC adapter, or the AC adapter and this unit not properly connected.
●
Be sure to plug the power plug firmly into the outlet.
ENGLISH
LD-HD1K.book Page 17 Tuesday, December 27, 2005 2:02 AM
